Craftsman 320.16490 Operator's Manual page 11

A
,_b, WARNING: Do not use this stand as scaffolding or as a ladder. Make sure to
tighten all locking knobs and levers securely prior to use, Maximum capacity is
330 Ibs. Power tools on the stand should not exceed a combined overall height
of 60 inches from the floor.
UNFOLD THE WORK LEGS
1. Place the frame assembly
with legs (A) upside-down on
a flat surface, as shown
in Fig. 2.
2. To open the top two legs,
press the locking pins and
rotate the legs until the
locking pins snap into the
open position and you hear a
"click" to signal that the legs
are locked in place (Fig. 3).
3. Open and lock the other two
legs the same way.
4. Place the frame assembly on a
flat surface as shown in Fig. 4.
Fig. 2
A
/ \
M / _
Press the locking
3in to move leg _,//"
Fig. 4
16490 Manual_Revised_12-0604 Page 11