Fasten The Door Bracket - Craftsman 139.53920DM Owner's Manual

INSTALLATION STEP 1 1
Fasten the Door Bracket
Follow instructions which apply to your door type
as illustrated below or on the following page.
A horizontal reinforcement brace should be long
enough to be secured to two vertical supports. A
vertical reinforcement brace should cover the height
of the top panel.
The illustration shows one piece of angle iron as the
horizontal brace. For the vertical brace, two pieces of
angle iron are used to create a U-shaped support
(Figure 1). The best solution is to check with your garage
door manufacturer for an opener installation door
reinforcement kit.
NOTE: Many vertical brace installations provide for direct
attachment of the clevis pin and door arm. In this case
you will not need the door bracket; proceed to Installation
Step 12.
SECTIONAL DOORS
• Center the door bracket on the previously marked
vertical centerline used for the header bracket
installation. Note correct UP placement, as stamped
inside the bracket (Figure 2).
• Position the bracket on the face of the door within the
following limits:
A) The top edge of the bracket 2"-4" (5-10 cm) below
the top edge of the door.
B) The top edge of the bracket directly below any
structural support across the top of the door.
Fiberglass, aluminum or lightweight steel garage doors WILL
REQUIREreinforcement BEFORE installation of door bracket.
Contact your door manufacturer for reinforcement kit.
HARDWARE SHOWN ACTUAL SIZE
Nut 5/16"-18 Lock Washer 5/16"
Carriage Bolt
5/16"-18x2-1/2"
• Mark and drill 5/16" left and right fastening holes.
Secure the bracket as shown in Figure 1 if there is
vertical reinforcement.
If your installation doesn't require vertical reinforcement
but does need top and bottom fastening holes for the door
bracket, fasten as shown in Figure 2.
Header Bracket
Door
Bracket
Location
Vertical
of Garage
Door
Horizontal and vertical reinforcement
is needed for lightweight garage doors
(fiberglass, aluminum, steel, doors with
glass panel, etc.). (Not Provided)
Vertical
Reinforcement
Vertical
,Centedine
,'of Garage
Door
of Door or
einforcement Board
\
5/16"-18x2-1/;
Door
Bracket
Lock Washer
5/16"
Nut
5/16"-18
"@t_.
@'_.
Door Bracket
Figure 2
UP
Figure
23