FOR GARDEN
TRACTORS
ONLY.
STEP 6:
(Figure 3)
Raise the tractor seat and remove the seat springs and
four bolts from the rear fender using a 1/2" socket.
STEP 7:
(Figure 3)
Place the hooked ends of the base bracket assembly
underneath the rear of the fender as shown.
STEP 8:
(Figure 3)
Attach the base bracket assembly and the seat springs to
the fender using the bolts and washers supplied with the
sun shade. Tighten the bolts using moderate force. Over-
tightening might damage the threaded holes in the fender.
STEP 9:
(Figure 3)
Insert the plastic caps into the ends of the base bracket
tube.
s
5/16"×1"
_\
HEX BOLT (13)
\
5/16" WASHER (9)
FIGURE
3
FOR ALL TRACTORS.
STEP 10: (Figure 4)
Assemble the upright tubes to the base bracket assembly.
5/16" FLAT
/_ _
WASHER (9) 1 J
,
PLASTIC /
/l 5/16' ×2"
BOLT
KNOB (8) /
i! CA/?IAGE
(14)
FIGURE 4
STEP 11"
(Figure 5)
Assemble the top tubes to the upright tubes. Do not
tighten yet.
STEP 12: (Figure 5)
Fit the front U-tube onto the top tubes. Fasten the tubes
together. Tighten all loose bolts and nuts.
STEP 13: (Figure 5)
Fit the three support rods into the holes in the top tubes,
with the rods arching upward. Do not over-bend the rods
when installing.
1/4" x 1-1/2"
HEX BOLT
U-TUBE
1/4" NYLOCK
NUT
/
114"x 1-1/2"
HEX BOLT
f
\'_.
SUPPORT ROD
TOPTUBES
1/4"
NUT
FIGURE 5
Call 1-866-576-8388
for missing parts or assembly help
5
DO NOT RETURN TO STORE