On/Off Switch And End Cap Assembly; Connecting Switch Cord To Motor Cord - Craftsman 152.221040 Owner's Manual

Figure 10=8
3. Slide the M6 square nuts and switch assembly (E)
into the left end of the front rail (F). See figure 11-1.
4. Position the switch assembly to desired location
and tighten hardware. CAUTION: Keep switch out
of saw blade path. Most common switch location is
to the left side of the saw blade.
AA
Figure 11=2
23. Note: The rip fence comes with a rear hold down
(AA) built into the end of the fence, to keep the rear
of the fence from lifting while using a feather board.
Engage the rear hold down by simply flipping down
on the hold-down arm so that it is under the rear
rail, as shown. See figure 10-8.
24. Check and make sure the rip fence is square to the
saw table and is parallel to the miter groove. If any
adjustments are needed see "FENCE ADJUST-
MENTS" in the Operation and Adjustments section
in this manual.
ON/OFF SWITCH AND
END CAP ASSEMBLY
5. Place the left front rail end cap (A) into the end
of the front rail (B). Attach end cap to rail with
two M4 x 16mm sheet metal screws (C).
See figure 11-2.
6. Repeat step above to attach right side front rail
end cap.
MAKE CERTAIN the table saw is disconnected from
the power source.
Figure 11=1
C
A
E
J
1. Place two M6 x 12mm hex head screws (A) up
through the two holes (B) in the switch support (C).
See figure 11-1.
2. Thread two M6 square nuts (D) onto M6 x 12mm hex
head screws about three turns. See figure 11-1.
CONNECTING SWITCH CORD
TO MOTOR CORD
MAKE CERTAIN the table saw is disconnected from
the power source.
Figure 12=1
1. Place the switch cord (A) through hole (B) in front
of cabinet. See figure 12-1.
21