Craftsman C950-60901-0 Owner's Manual page 9

ASSEMBLY
HOW TO ASSEMBLE THE STEERING WHEEL
Use the fasteners shown below to install the steering wheel. The
fasteners are shown at full size.
(A) (B)
lx102 15x88
1. Make sure the front wheels point forward.
2.
3,
Some models have an optional bellows, Slide _he bellows
over the steering post. Make sure the collar of the bellows is
on top (Figure 3).
Attach the steering wheel to the steering post with the fasten-
ers. Tighten the fasteners.
Steering Wheel
Steering Post
B
Bellows
Figure 3
CHECK THE TIRES
Check the air pressure in the tires, _res with too much air pressure
will cause the unit to ride rough. Also, the wrong air pressure will
keep the mower housing from cutting level. The correct air pressure
(PSI) is as follows,
Front Tires 22 PSI (1.5 BAR)
Rear Tires 14 PSI (1 BAR)
CHECK THE DRIVE BRAKE
The drive brake can be easily checked as follows.
1. Set the parking brake, See page 13,
2. Move the shift lever to the neutral (N) position.
3. Push the unit.
4. If the rear wheels rotate, adjust the drive brake. See "How To
Check And Adjust The Drive Brake" in the Customer
Responsibilities section.
CHECK THE BELTS
Check the routing of the belts. Make sure the belts are not twisted.
Make sure the belts are inside all the belt guides (Figure 4).
Belt Guides I
Transaxle Pulle
Motion Drive Belt
Belt Guide
Idler Pulley
Belt
I
Mower Drive Belt
Belt Guides
Figure 4
F-99635 9