Craftsman C950-60901-0 Owner's Manual page 7

ASSEMBLY
PREPARATION
The unit is completely assembled except for the items shown in
Figure 1. These items are in the carton along with a parts bag. The
parts bag contains the fasteners needed to complete the assembly
of the unit. Find and remove these items. Do not discard any parts
or material until the unit is assembled.
HOW TO REMOVE FROM THE CARTON
To remove the unit from the carton, follow the instructions below.
1. Open the top of the carton.
2. Remove the wood frame at the top of the carton.
3. Cut each corner of the carton from the top to the bottom with a
knife. Lower the sides of the carton to the ground.
4. Move the shift lever to the neutral (N) position.
NOTE: See the Operation section, page 11. for the location
of the controls.
5. If the parking brake is engaged, completely push the
clutch/brake pedal to release the brake.
6. Move the lilt lever to the highest position.
CAUTION: Check the bottom of the carton for staples.
Remove any staples that are in the path of the tires.
7. From the back of the dding mower, carefully pull the nding mow-
er backwards off the wood frame.
TOOLS YOU NEED TO ASSEMBLE THE UNIT
1. Adjustable wrench (2 required)
2. Open end wrench 1/2"-9/16"
3. Open end wrench 7/16" -1/2"
4. Blade type screwdriver
5. Phillips screwdriver
6. Low Tire pressure gauge
7. Knife
8. Socket Set (Optional)
Steering Wheel --
Bellows_
Parts Bag
Owner's Manual
Figure 1
MOWER PARTS BAG - CONTENTS
The fasteners and other loose parts are shown below. The fasteners are shown at full size. The quantity is shown in brackets ().
On some models, all of the fasteners are not required.
_j,iiiiiiiiiiiiii ©
lx102 18x16
(1) Hex Bolt (3) Carriage Bolt (2) Lockwasher
5/16"-18x1_/2• STD533107 STD551131
STD523115
©
lx45 15x88
(2) Hex Bolt (4) Flange Nut
s/16"-18x5/8" 5/16"-18
STD523106 STD541431
1x38 15x66
(2) Hex Bolt (2) Locknut
U4"-20X_/8" 1t4"-20
STD523106 STD541425
F-99635
54148
(1) Cover, Battery
Terminal
91275
(2) Ignition Key