How To Adjust The Attachment Clutch - Craftsman C950-60901-0 Owner's Manual

10 hp. electric start 30" mower / mulcher 5 speed rear engine rider
Table of Contents

Advertisement

CUSTOMER RESPONSIBILITIES
HOW TO ADJUST THE ATTACHMENT CLUTCH
,_
WARNING:
To prevent
an injury, the attachment
clutch must operate correctly.
1,
2.
3.
4.
5.
Stop the engine. Disconnect the wire from the spark plug.
Before you adjust the attachment clutch, check and level the
mower housing.
See "How To Level The Mower Housing."
Make sure the mower housing is level before go to the next
step.
Set the height of the mower housing in the lowest position.
Move the attachment
clutch to the DISENGAGE
position
(Figure 18).
Check the attachment clutch. Before the attachment clutch
engages, there must be 1/8" to 3/8" (3mm to 9mm) of free
movement.
8,
If an adjustment is needed, disconnect
the clevis from the
pivot rod and bracket assembly (Figure 19). Turn the clevis
clockwise to decrease the free movement of the attachment
clutch. Turn the clevis counterclockwise to increase the free
movement.
7,
Connect the clevis to the pivot rod and bracket assembly,
Move the attachment
clutch to the DISENGAGE
position.
Check the free movement of the attachment clutch.
8.
9.
Check the operation of the blade brake. Rotate the pulley with
your hand. Make sure that the blade brake pad presses tightly
against the pulley.
Move the attachment clutch to the ENGAGE position. Check
the pad for the blade brake. If the pad is excessively worn or
damaged,
replace
the
brake
pad
assembly.
Correct
replacement parts and assistance are available
from an
authorized service center.
10.
11.
12.
AttachmentClutch
Engage Postion
Disengage
..-'_
Positio_,_/
_Movement
1/8" - 318"(3mm - 9mm)
Figure 18
Attach the wire to the spark plug. Mow for a short distance and
again check the operation of the attachment clutch.
When you move the attachment clutch to the DISENGAGE
position, all movement will stop within five seconds if the ad-
justment is correct. If there is movement of the belt or the blade
continue to rotate, engage and disengage
the attachment
clutch five times to remove any excess rubber from a new
mower
drive
belt. If there is still blade rotation from the
DISENGAGED
position, again adjust the attachment clutch
beginning with the first step. If you need assistance, take the
unit to an authorized service center.
If you replace the mower drive belt, adjust the attachment
clutch.
Blade Brake
Mower Drive Belt
Pin
Figure 19
i
F-99635
20

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents