Advertisement
Available languages
Available languages
€.ANING
,'!ARNING I To
avoid
accidents, always disconnect the tool
from the power supply before cleaning
or performing any maintenance.
Avoid using solvents when cleaning plastic
parts. Most plastics are susceptible to
damage from various types of commercial
solvents and may be damaged by their
use. Use a clean cloth to remove dirt,
dust, etc.
I_WARNINGI
Do not at any time
allow brake fluids, gasoline, petroleum-
based products, penetrating oils, etc. to
come in contact with plastic parts. They
contain chemicals that can damage,
weaken or destroy plastic parts.
I WARNINGI
Always wear
safety goggles with side shields during
power tool operation or when blowing
dust. If an operation is dusty, also wear
e dust mask. Failure to do so could result
in possible serious injury.
Electric tools used on fiberglass material,
wallboard, spackling compound, or plaster
are subject to accelerated wear and
possibly premature failure because the
fiberglass chips and grindings are highly
abrasive to bearings, brushes,
commutators,
etc. As a result, we do not
recommend using this tool for extended
work with these types of materials.
However, if you do work with any of these
materials, it is extremely important to clean
the tool thoroughly with compressed air.
Ventilation openings and switch levers
must be kept clean and free of foreign
matter. Do not attempt to clean by
inserting pointed objects through
openings.
From t}me to time, the collet and toilet nut
should be cleaned. To do so, remove the
collet nut from the collet and remove any
accumulated dust and chips. Then reinstall
the collet nut to its original position.
SERVICE
iAWARN'NG]
When servicing, use only identical
Craftsman replacement parts. Use of
any other part may create a hazard or
cause product damage. We recommend
that all tool service be performed by a
Sears repair center.
Only the parts shown on the parts list are
intended to be repaired or replaced by the
customer. All other parts are an important
part of the double insulation system and
should be serviced only by a qualified
Sears service technician.
Cutters
Clean, sharp cutters provide faster and
more accurate cutting results. Remove
any accumulated pitch and gum from
cutters after each use.
When sharpening cutters, sharpen only
the inside of the cutting edge. NEVER
grind the outside diameter. When
sharpenening the end of a cutter, be
sure to grind the clearance angle the
same as it was originally ground.
Tool Lubrication
All bearings in this tool are lubricated with
a sufficient amount of high grade lubricant
for the life of the tool under normal
operating conditions. No further lubrication
is required.
15
Advertisement
