Table of Contents
Advertisement
Available languages
Available languages
PREPARE
THE HOOD
(NON - DUCTED HOODS ONLY)
Note: The following materials must be purchased separately for non-ducted recirculation
installations.
Non - Ducted Recirculation
Kit, Model 5304447635.
5" diameter duct.
1. Remove the tape on the electrical system plate; place the electrical system plate on the hood (use a protection). Fig. 12
2. Discard discharge collar/damper
supplied with the hood. Install the 5" to 6" adapter supplied with the Non-Ducted
Recirculation
Kit.
3. Secure the plenum to the flue mounting bracket with (2) 3.gx6mm flat head screws (the screws are supplied with the
Non-Ducted
Recirculation
Kit "5304447635").
Fig. 13.
ELECTRICAL
SYSTEM
PLATE
PROTECTION
5"-6"
3.9xGmm
FLUEMOUN_NG
FLATH_D
B_O!_q"
PLENUM
iNSTALL
THE HOOD
Note: at least two people will be required to mount the hood.
1. Raise
the hood into its mounting position.
2. Align the rectangular opening on the back of the hood with the wall-mounting
bracket. Gently lower the hood until it
securely engages the bracket.
Fig. I4.
3. Level the hood with (2) 3.9xg.5mm
mounting screws and secure with (2) 4.8x38mm
mounting screws. Use drywall
anchors provided if wal! studs or framing are not available.
Fig. 14.
4. Mount the electrical system plate attaching it with (3) 3.9x9.5mm mounting screws. Fig. 15.
5. On ducted hoods, attach 6" round metal duct between the hood's blower collar and duct that leads to the outside location.
6. On non-ducted
hoods, attach 5" round metal expandable duct between the 5"- 6" adapter on the hood the connector
on the plenum.
7. Tape all duct joints to make them secure and air tight.
8. Plug the power cord into the electric wall receptacle. Tuck excess cord behind the flue.
MOUNTING
SCREWS
MOUNTING
(4.8x38rnm)
SCREWS
MOUNTING
(4.8x38mrn)
WALL
MOUNTING
BRACKET
RECTANGULAR
OPENING
MOUNTING
SCREWS
(3.9x9.Smm)
PLATE OF
,_
THE
i
ELECq'RICAL
SYSTEM
-7-
Advertisement
Table of Contents
