Table of Contents
Advertisement
LEFT 00
LEFT O0
REAR O0
FRONT
00
Figu re 1
O0 R_GHT 00 RIGHT
00
FRONT
O0
REAR
ControJ Locations
of the Gas Surface
Burners
Your range is equipped with gas surface burners with 3
different BTU ratings. The ability to heat food quicker and
in iarger volumes increases as the burner size increases.
The small StaMMER burner is best used for simmering
deHbate sauces, etc. This burner is located at the right rear
burner position on the cooktop (see figure 1).
The STANDARD
burners can be used for most surface
cooking needs. The 2 burners are located at the Heft f ront and
rear burner positions on the cooktop (see figure 1 ).
The POWER bumeris best used for bringing iargequantitbs
of Hquid rapidly up to temperature or when preparing larger
quantities of food. The POWER burner is located at the Heft
front burner position on the cooktop (see figure 1).
Regardless of size, always select cookware that is suitable
for the amount and type of food being prepared. Select a
burner and flame size appropriate to the pan. Never allow
flames to extend beyond the outer edge of the pan.
bi
\
OFF
reed
Figure2
Operating
the Gas
Surface
ControJs:
1.
Piace cooking utensii on surface burner.
2.
Push the surface control knob down and turn counterclockwise
out of the OFF
position.
3.
Release the knob and rotate to the LMTEposition (see figure 2). Note: AiMfour
electronic surface ignitors wiil spark at the same time. However, only the burner you
are turning on wiil ignite.
4.
Visualiy check that the burner has a flame.
5.
Turn the control knob counterclockwise
to the desired flame size. The control
knobs do not have to be set at a particular setting. Use the knob indicator settings
to adjust the flame as needed. DO NOT cook with the surface control knob in the
LMTEposition. (The electronic ignitor wiil continue to spark if the knob is Heftin the
LMTEposition.)
Do not place pJastic items such as saJt and pepper shakers, spoon holders or pJastic wrappings
on
top of the range when it is in use. These items could melt or ignite. Pothoiders, towels or wood spoons could catch fire
if piaced too chose to a flame.
in the event of an electrical power outage, the surface burners can be lit manually, To light a surface burner, hold a lit match
to the burner head, then slowly turn the surface control knob to UTE, After burner lights turn the knob to desired setting, Use
caution when lighting surface burners manually,
Advertisement
Table of Contents
