Table of Contents
Advertisement
So/utions
to Common
Problems
OCCURRENCE
Range is not level
POSSmBLE CAUSE/SOLUTmON
Poor instaIIation. Place oven rack in center of oven. Place a level on the oven rack.
Adjust bveling
legs at base of range until the rack is Ievek When range is level,
cooktop may appear out of alignment if countertop is not bvek
Weak, unstable floor. Be sure floor is level and can adequately
support range. If floor
is sagging or slopping, contact a carpenter to correct the situation.
Kitchen cabinet misaIignment
may make range appear to be unleveL Be sure
cabinets are square and have sufficient
room for range clearance.
Cannot move appliance
easily.
Appliance
must be accessibme for
service.
Cabinets not square or are built in too tight. Contact a cabinet maker to correct the
problem.
Contact builder or installer to make appliance accessible.
Carpet interferes with range. Provide sufficient space so range can be lifted over
carpet.
Gas Iine is hard@Iumbed.
Have a flexible C.S.A international
approved metal
appliance
connector
installed.
Entire range or oven does not operate.
Make sure cord/plug is plugged tightly into outlet.
Service wiring is not complete. Call an authorized
servicer.
Electrical power outage. Check house lights to be sure. CalI your local electric
company for service. Surface burners can be lit manually.
*Oven contro_ beeps and displays
any F
Electronic control has detected a fault condition. Press STOP/CLEAR
to clear the
code error (for exampme Fll)
display and stop beeping. Reprogram oven. If fault recurs, record fault number. Press
STOP/CLEAR
and call an authorized servicer
for assistance.
Oven light does not work.
Replace or tighten bulb. See Changing
Oven Light section in this Use & Care Guide.
Electrical power outage. Check house lights to be sure. CalI your local ebctrb
company for service.
Surface burners
do not might,
Surface control knob has not been completely turned to LITE. Push in and turn the
surface control knob to LITE until burner ignites and then turn the surface control
knob to the desired flame size.
Burner ports are clogged. Clean burners. See "Cleaning
the Burner Grates, Burner
Caps and Burner Heads" under General Cleaning.
Range power is disconnected
from outlet. Be sure cord is securely plugged into the
outlet.
Electrical power outage.
Surface
burner flame burns haft way
around.
Be sure the gas supply to the range is turned "ON".
Burner ports or slots are clogged. With the burner off, use a smalPgauge wire or
needle to clean ports or slots.
Moisture is present after cleaning. Lightly fan the flame and allow the burner to
operate until flame is full. Dry the burners thoroughly
following instructions
under
General
Cleaning.
22
Advertisement
Table of Contents
