Rack Positions - Frigidaire CPDF4085KF2 Use & Care Manual

OVEN VENT LOCATION
Each oven has its own vent as shown below (Figure
i). When the oven is ON, warm air is released through
the vent. This venting is necessary for proper air
circulation in the oven and good baking results. DO NOT
BLOCK OVEN VENT, Never close off the openings with
aluminium foil or any other material.
Auxiliary oven vent
Figure 1
Main overt vent
ARRANGING OVEN RACKS
ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN IS
COOL (PRIOR TO OPERATING THE OVEN). Always use
oven mitts when using the oven.
To remove an oven rack, pull the rack forward until it
stops. Lift up front of rack and slide out (Figure 4).
To replace an oven rack, fit the rack onto the guides
on the oven walls. Tilt the front of the rack upward and
slide the rack back into place.
11
Figure 4
RECOMMENDED RACK POSITIONS
This unit is equipped with a blower which runs
in baking and self=cleaning mode to keep all
internal components at a cool temperature,
The blower may keep running even if the oven
has been turned OFF, until the components
have cooled down,
AIR CIRCULATION IN THE OVEN
Ifusingi rack(Figure 2),placeincenter of oven.Ifusing
multiple racks (Figure 3), stagger cookware as shown.
For best air circulation and baking results allow 2-4"
(5-10,2 cm) around the cookware for proper air
circulation and be sure pans and cookware do not touch
each other, the oven door, sides or back of the oven
cavity. The hot air must circulate around the pans and
cookware in the oven for even heat to reach around the
food.
Broiling meats, chicken or fish
Using a single rack
Using multiple racks
(If equipped with an offset rack)
2or3
2, 3 and 4
1, 3 (offset) 4
Turkey, roast or ham ..........................
i
Figure 2 = Single Oven Rack
Figure 3 = Multiple Oven Racks
Figure 5
Rack
positions
Always use caution when removing food from the oven.