Rack Positions - Frigidaire FGEF306TMFB Use & Care Manual

ARRANGING OVEN RACKS
ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN IS
COOL (PRIOR TO OPERATING THE OVEN). Always use
oven mitts when using the oven.
To remove an oven rack, pull the rack forward until it
stops. Lift up front of rack and slide out.
To replace an oven rack, fit the rack onto the guides
on the oven walls. Tilt the front of the rack upward and
slide the rack back into place.
Rack
RECOMMENDED RACK POSITIONS
Broiling meats, chicken or fish 3 3
Cookies, cakes, pies, biscuits & muffins
Using a single rack 2 2
Using two racks i and 3 i and 3
Using multiple racks 1, 2 and 3 1, 2 and 3
Frozenpies,angelfoodcake, yeast,bread,1 1 or 2 1 or 2
or 2 casseroles, s mallcuts of meator poultry
Turkey, roast or ham 1 1
AIR CIRCULATION IN THE OVEN
If using 1
rack,
place in center of oven. If using multiple
racks, stagger cookware as shown.
For best air circulation and baking results allow 2-4"
(5-10 cm) around the cookware for proper air circulation
and be sure pans and cookware do not touch each other,
the oven door, sides or back of the oven cavity. The hot
air must circulate around the pans and cookware in the
oven for even heat to reach around the food.
Oven vents location
The upper and lower ovens
are vented at the back of
the cooktop. When an oven
is on, warm air is released
through its vent. This venting
is necessary for proper air
circulation in the oven and
good baking results. DO
NOT BLOCK OVEN VENTS.
Never close off the openings
with aluminium foil or any
other material.
TYPES OF OVEN RACKS
Your built=in range may be equipped with one or more of
the oven racks styles shown;
• Flat handle oven rack.
• Offset oven rack.
Figure 1
Flat handle oven rack
Figure 2
Offset oven rack
Multiple Oven Racks
Always use caution when removing food from the oven.
Always use pot holders or oven mitts when adjusting the
oven racks. Wait until the oven has completely cooled if
possible. Oven racks may be HOT and may cause burns.
The Flat Oven Handle Rack (Figure 1) has a handle
to facilitate the sliding of the rack when large amount of
foods weight on it.
The Offset Oven Rack (Figure 2) is used to maximize
cooking space. The offset rack can be used in the lowest
rack position to roast large cuts of meat and poultry or for
specific type of cooking.