Advertisement
Figure
12
s
f
Figure 13
I
Figure 14
18,
19.
20.
21.
Carefully lift the saw with the attached extrusions and place onto the
leg/frame assembly, Adjust the saw front/back along the extrusion to balance
the saw on the frame. The mounting hook and clamp angle can also be
adjusted to further balance the saw, and to equally space the mounting
brackets along the extrusion.
Slide the mounting hook and clamp angle under the table top tube as
shown in Figure 13. Tighten all the bracket fasteners and the saw mounting
fasteners. The saw and extrusions can now be secured to the stand by
tightening the 5/16"-18 x 1-1/2", 3-point knobs installed in Step 14.
Install the multi-stop onto right or left support T. Attach the multi-stop to
the T with special shoulder bolt, passed through the round hole in the
multi-stop, through the round hole in the support T and into the threaded
mounting plate positioned on the inside of the T. Align the mounting plate
with an adjacent hole in the support T and install a 5/16"-18 x 1/2" 3-point
knob to hold the multi-stop in place. Figure 14 and 15.
The multi-stop can be used on the right or left support T. It may also be
positioned anywhere along the length of the T. Use as a bump stop for
repetitive cuts or as a fence style stop for squaring material to the blade.
Install the wheels onto the axle brackets with the integrated spacer facing
towards the center of the stand. Secure with the latch pin, passed through the
hole in the axle bracket. Figure 16.
Figure 15
Figure 16
6
Advertisement
