Advertisement
_Weld
Nut
Figure 2
Figure 3
Assembly Instructions
Read all assembly instructions
completely before attempting assembly.
See parts list on Page 2 for names and pictures of parts. Figure 1.
1.
identify all components and hardware.
2.
Place top frame upside down on your workbench or work surface. Position
so that the nuts welded to the top of the frame tubes will be positioned in
the lower right and upper left when the frame is turned over for assembly.
Figure 2.
3.
Attach the wheel axle brackets to the left end of the frame. Note you will have
a right and left bracket. When the mounting holes are aligned, the correct
_bracket will position the axle parallel to the work surface. Secure with 1/4"- 20
_X 5/8" hex bolts from the inside of the frame, 1/4"- 20 Nylok nuts on the
outside of the frame. Figure 2.
NOTE: For easy movement with the stand fully opened, attach the wheers to
the outside of the lower legs as shown in Figure 3. If you choose this position,
complete this portion of the assembly as your last step.
Use (2) 1/4"-20 x 1-3/4" hex bolts and (2) 1/4"-20 Nylok nuts per leg.
Figure 4
Figure 5
Figure 6
4.
,
6_
Install snap buttons intothe top end of the straight legs. Carefully guide the
snap buttons into position with a screw driver until it pops into the large
through hole in the top of the legs. Straight legs will be installedon the left
end of the frame. Figure 4.
Install snap buttons into the top of the curved legs. These will be oriented as
left and right (front/back) during assembly. Curved top legs will be attached to
the right end of the frame. Figure 1 shows the correct installation of the snap
buttons and correct right/left orientation.
Attach the straight legs to the frame using (1) 1/4"- 20 x 2" carriage bolt,
(1) 5/16" flat washer and (1) 1/4"- 20 Nylok nut per leg. Bolt will pass
through the flat washer, then through the left hole in the frame plate closest
to the frame tube, through the top hole in the leg and through the bracket
on the inside of the frame. Secure with 1/4"- 20 Nylok nut. Figure 5.
Repeat this procedure for the leg directly opposite (back).
NOTE: Tighten the leg fasteners so the legs are stiff when folding or opening
the stand.
4
Advertisement
