Advertisement
7,
Attach the left curved legs to the frame using (1) 1/4"- 20 x 2" carriage bolt,
(1) 5/16" flat washer and (1) 1/4"- 20 Nylok nut per leg. Use the hole which is
second from the right, closest to the frame tube to attach the leg. Pass the
bolt through the flat washer, then through the hole in the outside of the frame,
through the top hole in the leg, through the bracket on the inside of the frame,
and secure with 1/4"- 20 Nylok nut. Figure 6 and 7.
Repeat this procedure
for the right (back) leg.
8.
Install 1-1/4" angled tube plugs into the bottom of all four legs. Plug angle will
match the leg angle to allow the stand to sit flush on the floor.
Figure 7
9,
Rotate both the right and left legs to be sure the spring plugs engage the
holes in the frame plate in the extended and collapsed position. Fold the left
legs down. Fold the right legs down. Be sure the right legs nest neatly over
the left legs and lock in position for transport.
10. Return legs to extended positions. Carefully stand the assembly upright on
the floor.
Figure 8
11. Thread 5/16"- 18 x 1/2" 3-point knobs into the weld nuts on the top of
the frame tube. Install the outrigger support and secure in place with the
3-point knob.
12. Thread 5/16"- 18 x 1/2" 3-point knobs into the outrigger ends. Install
support T's as shown, secure with 3-point knob. Figure 8.
13. Carefully review Figures 9, 10 and 11. Both the mounting hook and the
clamp bracket are Right/Left specific. Begin by sliding (4) 1/4"-20 x 5/8"
hex bolts into the small "T" slot on each aluminum extrusion.
14. Attach the mounting hook and clamp bracket to the extrusion using the
1/4"-20 hex bolts installed in Step 15 and (4) 1/4"-20 serrated flange nuts
per extrusion. Thread 5/16"-18 x 1-1/2", 3-point knobs onto the clamp
brackets as shown. Hand tighten only.
15. Slide (4) T-bolts into the large (top) slot on the aluminum extrusion. Space
them to the approximate distance required to mount the saw. Figure 11.
16. Carefully lift the saw up and place onto the aluminum extrusion, passing
the T-mounting bolts installed in Step 15 through the mounting holes in the
base of the miter saw. Figure 12.
1;
L
"_'!L 11 ]
Figure 11
17. Secure the saw in place on the aluminum extrusion with (1) 5/16" flat
washer, (1) 5/16" lock washer, and (1) 5/16" hex nut per T-mounting bolt.
Hand tighten only.
5
Advertisement
