Flow Control Mount Bracket; Wheels (Drive And Idler) - Craftsman 486.243232 Owner's Manual

Turnthe spreader upright o nitswheels.
Assemble t hehitchbracket t othetopofthehitch
tubeusingtwo1/4"x 1"hexboltsand1/4"nylock
nuts.Seefigure5.
Assemble t hehitchpinthrough the hitchbracket a nd
thehitchtubeandsecure withthehaircotterpin.See
figure5.
HITCH PIN
_"""""'-_ HAIR COTTER PIN
FIGURE 5
Assemble the flow control link (end with small hole)
to the flow control arm using a 1/4" x 1" hex bolt, a
nylon washer and a 1/4" nylock hex nut as shown in
figure 6. Tighten carefully. The flow control link
should not be loose but should pivot with no more
than slight resistance.
FLOW CONTROL
LINK
I FLOW
CONTROL
J ARM
0/ 1/4"
J Y'OCKNUT
FIGURE 6
• Assemble the flow control arm to the flow control
mounting bracket using a 1/4" x 1" hex bolt, two
nylon washers and a 1/4" nylock hex nut as shown in
figure 7. Tighten carefully. The flow control arm
should not be loose but should pivot with no more
than a slight resistance.
• Place the vinyl grip onto the flow control arm. See
figure 7.
VINYL GRIP
FLOW CONTROL
FLOW MOUNTING
CONTROL BRACKET
ARM
/
1/4" xl"
HEX BOLT
1/4"
NYLOCK NUT
(2)NYLON
WASHERS
FIGURE 7
Place a 5/16" flat washer onto the end of the flow
control rod. Insert the end of the rod through the slot
in the flow control mounting bracket and through the
hole in the flow control link. Secure with a 3/32" x 3/4"
cotter pin. See figure 8.
5/16" FLAT
WASHER
3/32"
COTTER
PIN
FLOW
CONTROL
ROD
\
SLOT
FLOW
CONTROL
LINK
FIGURE 8
7