Operation; Shoulder Strap Adjustment; Know Your Blower - Craftsman 358.797310 Instruction Manual

SHOULDER STRAP ADJUSTMENT
(for vacuum use only)
1. Hold the unit as shown.
2. Pass the shouider strap over your
head and onto your right shoulder.
3. Extend you left arm toward the rear
of the vacuum bag.
4 Adjust shouider strap until the vac-
uum bag/shoulder strap seam lies
between your thumb and index
finger.
5. Make sure air flows freety from the
elbow tube into bag. tf bag is
kinked, the unit witt not operator
properly.
KNOW YOUR SLOWER
READ THiS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
UNiT Compare the illustrations with your unit to familiarize yourself with the loca-
tion of the various controts and adjustments. Save this manual for future refer-
ence,
Spark Plug
Blower
Tube_
Vacuum Bag
J Upper
Throttle Lever ON/STOP
Primer Switch
Button 2 _ Fuet Mix
LCehv °_e Z_,_ Starte r
Elbow
Tube
Lower
Vacuum Tube
ON/STOP SWITCH
The ON/STOP switch is used to stop
the engine, The switch stays in the ON
position. To stop engine, push and
hoId the switch in the STOP position
until the engine comes to a comptete
stop.
THROTTLE LEVER
The THRO_LE LEVER controls engine
speed. Move it atl the way forward for
fuII speed operation. Move it all the way
backward for idte speed.
PRIMER BUTTON
The PRIMER BUTTON removes air from
the carburetor and fuel tines and fiils
them with fuel. This allows you to start
the engine with fewer pulls on the
starter rope. Activate primer button by
pressing it and atlowing it to return to
its original position.
CHOKE LEVER
The CHOKE helps to suppiy fuet to the
engine to aid in cotd starting. Activate
the choke by moving the choke tever
to the FULL CHOKE position. After en-
gine attempts to start, move the choke
lever to the HALF CHOKE position.
Once engine starts, move choke lever
to the RUN position,
-6-