Advertisement
Quick Links
Instruction
Manual
I CRAFTSMAN°I
25cc/1.5
cu.in. 2-Cycle
205 MPH/410
CFM
GASOLINE
POWERED
BLOWER/VAC
Model
No.
358.797341
•
Safety
i ssem ,,
Operation
Maintenance
_j_
_
PartsList
Espar__
WARNING:
Read and follow all Safety Rules and Operating
Instructions before first use of this product.
For answers to your questions
about this product:
Call 7 am-7
pm, Mon.-Sat.,
or 10 am-7
pm, Sun.
1-800-235-5878
(Hours listed are Central Time)
Sears, Roebuck
and Co., Hoffman
Estates,
IL 60179 U.S.A.
530088069
t0/1/0t
Advertisement
Related Manuals for Craftsman 358.797341
Summary of Contents for Craftsman 358.797341
- Page 1 Instruction Manual I CRAFTSMAN°I 25cc/1.5 cu.in. 2-Cycle 205 MPH/410 GASOLINE POWERED BLOWER/VAC Model 358.797341 • Safety Operation i ssem ,, Maintenance PartsList Espar__ WARNING: Read and follow all Safety Rules and Operating Instructions before first use of this product. For answers to your questions...
- Page 2 Maintenance Spanish Service & Adjustments Parts and Ordering Back FULL TWO YEAR WARRANTY ON CRAFTSMAN ® GAS BLOWER For two (2) years from date of purchase, when this Gas Blower is maintained, lubricated, and tuned up according to the instructions...
- Page 3 • Do not operate unit when you are thrown out through discharge open- tired, ill, upset, or if you are under the ing, damaging unit, property, or caus- influence of alcohol, drugs, or medica- ing serious injury to bystanders tion. operator.
- Page 4 • Empty fuel tank before storing the unit. who operate power tools on a continual Use up fuel left in carburetor by start- and regular basis must monitor closely ing engine and letting it run until it their physical condition and the condition of this tool.
- Page 5 Insert a screwdriver into the latch VACUUM ASSEMBLY area on the vacuum inlet cover. VACUUM BAG ASSEMBLY 1. Open tile zipper on the vacuum bag and insert the elbow tube. ] _,, Outlet Push the small end of the elbow ,_ ,.a_"...
- Page 6 SHOULDER STRAP ADJUSTMENT (for vacuum use only) 1. Hold the unit as shown. Pass the shoulder strap over your head and onto your right shoulder. Extend your left arm toward the rear of the vacuum bag. 4. Adjust shoulder strap until the vac- uum bag/shoulder strap seam lies between your thumb and index...
- Page 7 2-cycle air-cooled engine oil. be disturbed. Comply with times listed We recommend Craftsman brand oil. in local ordinances. Usual recommen- Mix gasoline and oil at a ratio of 40:1 dations are 9:00 a.m. to 5:00 p.m., (A 40:1 ratio is obtained by mixing 3.2...
- Page 8 STARTING THE ENGINE NOTE: If the engine attempts to start before the 5th pull, go to the next step _,WARNING: You MUST make sure immediately. the tubes are secure before using the 5. Move choke lever to HALF CHOKE. unit. 6.
- Page 9 CUSTOMER RESPONSIBILITIES CARE & MAINTENANCE TASK WHEN TO PERFORM Before each use Check for loose fasteners and parts Before each use Check for damaged or worn parts After each use Inspect and clean unit and labels Clean air filter Every 5 hours of operation Replace spark plug Yearly Replace fuel filter...
- Page 10 REPLACE SPARK PLUG CHECK MUFFLER MOUNTING SCREWS Replace spark plug each year to ensure the engine starts easier and runs better. Once each year, ensure muffler Set spark plug gap at 0.025 inch. Igni- mounting screws are secure and tight- ened properly to prevent damage, tion timing is fixed, nonadjustable.
- Page 11 Run unit before storing or transporting. engine at least 5 minutes after adding • Store unit and fuel in a well venti- stabilizer. Craftsman 40:1,2-cycle lated area where fuel vapors cannot gine oil (air cooled) is already blended reach sparks or open flames from with fuel stabilizer.
- Page 12 TROUBLESHOOTING TABLE WARNING: Always stop unit and disconnect spark plug before perform- ing any of the recommended remedies below other than remedies that re- quire operation of the unit. TROUBLE CAUSE REMEDY 1. Engine flooded. Engine will not 1. See "Starting a Flooded Engine"...
- Page 13 MANUFACTURER'S WARRANTY vice center or call Sears at 1-800-469-4663. WARRANTY COVERAGE: If any emissions related part on your engine (as listed under RIOD: Any warranted part which is not Emissions Control Warranty Parts List) scheduled for replacement as required is defective or a defect in the materials maintenance, or which is scheduled or workmanship...