Operation - Craftsman CMXGAAMA27BL Operator's Manual

Electric start capable 2-cycle handheld blower
Table of Contents

Advertisement

Available languages

Available languages

WARNING:
To prevent serious personal injury, never
operate the unit without the blower tubes securely attached.
WARNING:
Always wear eye, hearing, hand, foot and body
protection to reduce the risk of injury when operating this unit.
Wear a face mask or dust mask if the operation is dusty.
HOLDING THE UNIT
Stand in the operating position (Fig. 9). Stand up straight. Do not
bend over.
Keep feet apart and firmly planted.
Hold the unit with a firm grip.
Hold the unit in front of, and away from, your body (Fig. 9).
WARNING:
To prevent serious personal injury or damage
to the unit, DO NOT hold the unit at your side (Fig. 9). The
engine may be extremely hot. DO NOT block the air intake.
TIPS FOR BEST RESULTS
Conserve water by using the blower instead of a hose to
perform many outdoor cleaning actions.
Operate the unit only at reasonable hours, not early in the
morning or late at night when people might be disturbed. Comply
with times listed in local ordinances. Usual recommendations are
9:00 a.m. to 5:00 p.m., Monday through Saturday.
To reduce noise levels, operate the unit at the lowest speed
needed to do the job. Limit the number of pieces of power
equipment used at any one time.
Use rakes or brooms to loosen debris before operation.
In dusty conditions, slightly dampen surfaces.
Use the cruise control to make continuous operation easier (Fig. 5).
Watch out for children, pets, open windows and freshly washed
cars. Blow debris safely away. Never direct the unit toward
anyone while the unit is in operation.
Sweep the unit from side to side with the blower tube several
inches above the ground. Slowly advance, keeping the
accumulated debris in front of the operator.
Use the nozzle to concentrate the air stream closer to the ground.
Clean up after operation. Dispose of debris appropriately.

OPERATION

11
Handle
Air Intake
Fig. 9

Advertisement

Chapters

Table of Contents
loading

Table of Contents