Download Print this page
Craftsman 358.797342 Instruction Manual

Craftsman 358.797342 Instruction Manual

25cc/1.5 cu.in. 2-cycle 205 mph/410 cfm gasoline powered blower/vac

Advertisement

Available languages

Available languages

Quick Links

Instruction Manual
25cc/1.5 cu.in. 2-Cycle
205 MPH/410 CFM
GASOLINE
POWERED
BLOWER/VAC
Model No.
358.797342
• Safety
• Assembly
• Operation
• Maintenance
• Parts List
• Espa_ol
WARNING:
Read and follow all Safety Rules and Operating
Instructions before first use of this product.
For answers to your questions about this product:
Call 7 am-7 pm, Mon.-Sat.,
or 10 am-7 pm, Sun.
1-800-235-5878
<.o°,,
listed are Central Time)
Sears, Roebuck
and Co., Hoffman
Estates,
IL 60179 U.S.A.
530163801
7/25/03

Advertisement

loading

Summary of Contents for Craftsman 358.797342

  • Page 1 Instruction Manual 25cc/1.5 cu.in. 2-Cycle 205 MPH/410 CFM GASOLINE POWERED BLOWER/VAC Model No. 358.797342 • Safety • Assembly • Operation • Maintenance • Parts List • Espa_ol WARNING: Read and follow all Safety Rules and Operating Instructions before first use of this product. For answers to your questions about this product: Call 7 am-7 pm, Mon.-Sat., or 10 am-7 pm, Sun.
  • Page 2 Parts and Ordering Back Storage FULL TWO YEAR WARRANTY ON CRAFTSMAN ® GAS BLOWER For two (2) years from date of purchase, when this Gas Blower is maintained, lubricated, and tuned up according to the instructions in the instruction manual, Sears will repair, free of charge, any defects in material or workmanship.
  • Page 3 • Do not set unit on any surface ex- cept a clean, hard area while engine • Use only recommended Craftsman ® is running. Debris such as gravel, replacement parts; use of any other parts may void your warranty and sand, dust, grass, etc.
  • Page 4 • Empty fuel tank before storing the unit. who operate power tools on a continual Use up fuel left in carburetor by start- and regular basis must monitor closely ing engine and letting it run until it their physical condition and the condition of this tool.
  • Page 5 VACUUM ASSEMBLY Latch Blower Areha_l Outlet VACUUM BAG ASSEMBLY 1, Open the zipper on the vacuum bag and insert the elbow tube. 2, Push the small end of the elbow " @= Inlet Cover tube through the small opening in the bag, 3, Gently tilt the handle of the screw- Elbow...
  • Page 6 3, Extend your left arm toward the rear of the vacuum bag. 4. Adjust shoulder strap until the vac- uum bag/shoulder strap seam lies between your thumb and index finger. 5. Make sure air flows freely from the elbow tube into bag. If bag is kinked, the unit will not operate properly.
  • Page 7 2-cycle air-cooled engine oil. • In dusty conditions, slightly dampen We recommend Craftsman brand syn- surfaces or use a mister attachment thetic oil. Mix gasoline and oil at a ratio when water is available.
  • Page 8 Craftsman brand oil is already blended through the discharge opening, damag- with fuel stabilizer. See the STORAGE ing the unit or property, or causing seri- section for additional information.
  • Page 9 8. Allow the unit to run for 30 more 3. To stop the engine, move the seconds at RUN before moving the throttle lever to the STOP position. throttle lever to the "_P position. If the engine has not started after 5 STARTING A FLOODED ENGINE pulls (at HALF CHOKE), repeat the Flooded engines can be started by plac-...
  • Page 10 INSPECT AND CLEAN UNIT REPLACE FUEL FILTER AND LABELS To replace fuel filter, drain unit by run- , After each use, inspect complete unit ning it dry of fuel, then remove fuel cap/retainer assembly from tank. Pull for loose or damaged parts. Clean filter from tank and remove it from the the unit using a damp cloth with a fuel line.
  • Page 11 • Store unit and fuel in a well venti- engine at least 5 minutes after adding lated area where fuel vapors cannot stabilizer. Craftsman 40:1, 2-cycle en- reach sparks or open flames from gine oil (air cooled) is already blended water heaters, electric motors or with fuel stabilizer.
  • Page 12 TROUBLESHOOTING TABLE WARNING: Always stop unit and disconnect spark plug before perform- ing any of the recommended remedies below other than remedies that re- quire operation of the unit, TROUBLE CAUSE REMEDY Engine will not 1. Engine flooded. 1. See "Starting a Flooded Engine" start, in Operation section.
  • Page 13 OWNER'S WARRANTY RESPONSI- place as necessary" shall be war- BILITIES: AS the small off-road ranted for 2 years. Any warranted part gine owner, you are responsible for the which is scheduled for replacement as performance of the required mainte- required maintenance shall be war- nance listed in your instruction manual.
  • Page 14 DE DOS A_IOS COMPLETOS PARA EL PROPULSOR DE AIRE A GASOLINA DE LA MARCA CRAFTSMAN ® Durante dos (2) a_os a partir de la fecha de compra, siempre que se haga el mantenimiento, la lubricaci6n y los ajustes en este Propulsor de Aire a Gasolina...
  • Page 15 PIENSE ANTES DE PROCEDER • Evite derramar el combustible o el • Use siempre protecci6n para los ojos aceite. Limpie todos los derrames al hacer uso, servicio o mantenimk de combustible antes de porter el ento del aparato. El uso de proteci6n aparato en marcha.
  • Page 16 • Use exclusivamente los repuestos ida en perfecto estado de funcionamien- recomendados de la marca to, o que el motor est6 construido y Craftsman®; el use de cualquier otro equipado para la prevenci6n de incen- -19-...
  • Page 17 dies y mantenido correctamente. Con- cional. Si se requiere rejilla anti-chispa suite con las autoridades estatales o lo- en la Iocalidad donde usted se encuen- cales acerca de los reglamente que se tra, entre en contacto con el Servicio de relacionene con estos requisitos.
  • Page 18 Entrada de Aire 0e, A,0, a0o Moldura ilanura 5, Coloque los ganchos que se encuentran en el tubo de aspiraci6n superior en el poste de retenci6n del aparato. 5, Introduzca el tubo en forma de 6, Gire el tubo hasta que este fijo por codo en la salida de aire del ]a cerradura de la entrada de aire.
  • Page 19 5. Vuelva a instalar los tubo de 5. AsegDrese de que el aire circule propulsi6n (vea INSTALACION DEL libremente desde el tubo en forma de codo hasta la bolsa. Si la bolsa TUBO DE PROPULSION). se encuentra torcide, el aparato no AJUSTE DE LA BANDA DEL HOMBRO funcionar_ apropiadamente.
  • Page 20 PALANCA DEL ACELERADOR motor en marcha con menos firones de La PALANCA DEL ACELERADOR se uso la cuerda de arranque. Active el boton para seleccionar la velocidad deseada del bombeador apret_ndolo y huego y para detener el motor. Mueva la pa- dejando que retome su forma original.
  • Page 21 ABASTECIMIENTO DEL MOTOR en el combustible durante el almace- naje. El aceite de la marcha Craftsman ADVERTENClA: Remueva la viene ya mezclado con estabilizador tapa del tanque de combustible lenta- de combustible. Vea la secci6n de AL- mente al reabastecer combustible.
  • Page 22 7. Despu6s de calentar por 5 segun- ADVERTENCIA: AI arrancar el dos, mueva la palanca del cebador motor, sostenga el aparato como se a la posici6n RUN. ilustra en la figura. Apoye el aparato 8. Permita que el aparato siga en exclusivamente en una superficie lim-...
  • Page 23 RESPONSABILIDAD DEL USUARIO ADVERTENCIA: Desconecte la bujia antes de realizar mantenimiento, servicio, o ajustes. TAREA DE CUIDADO Y MANTENIMIENTO CUANDO HACER Antes de cada uso Verificar que no haya fijadores flojos ni piezas sueltas Antes de cada uso Verificar que no haya piezas daSadas o gastadas Despu6s de cada uso Inspeccione y limpie el aparato y sus placas Cada 5 horas de use...
  • Page 24 Siempre limpie el filtro de aire despu6s VERIFICAR TORNILLOS MONTAJE DEL SILENCIADOR ded cada 5 horas de uso. Limpieza del filtro del aire: Para prevenir da_os, aseg_rese anu- almente de que los tornillos de mon- 1. Limpie la cubierta y el _rea conti- gua para evitar que caiga tierra en taje del silenciador se encuentren...
  • Page 25 El aceite de la marca Craftsman 40:1 el6ctricos, calefactores centrales, para motores a 2 tiempos (enfriados a etc. aire) ya viene mezclado con estabiliza- •...
  • Page 26 TABLA DIAGNOST|CA ADVERTENCIA: Siempre apague el aparato y desconecte la bujfa antes de hacer cuaiquiera de Ins reparaciones recomendadas a continuaciEn que )eraciEn. no requieran que la unidad est6 en c SINTOMA CAUSA SOLUCION El motor no 1, El motor est_ ahogado, 1, Vea "Arranque de Motor Ahogado"...
  • Page 27 SUS DERECHOS Y OBUGACIONES tar con el conocimiento de que Sears DE GARANTIA: La Agencia de Pro- puede negar la cubierta bajo garantia tecci6n Ambiental de los Estados Uni- si su m_quina de motor pequeSo para dos y Sears, Roebuck and Co., uso fuera de carretera o alguna pieza U.S.A., se cemplacen en explicar la de la misma ha dejado de funcionar...
  • Page 28 ento requerido deber_ estar garantiza- da con sus derechos y responsabili- da por el periodo de tiempo que com- dades de garantia, usted deber_ en- ienza en la fecha de compra inicial trar en contacto con su distribuidor hasta la fecha de] primer reemplazo torizado del servicio Sears m_s cerca- programado para dicha pieza.