Table of Contents
Advertisement
Instruction
Manual
(RRFTSMR
24cc/1.4 cu.in. 2-Cycle
200 MPHi400 CFM
GASOLINE
POWERED
BLOWER/VAC
Model No.
358.797310
•
Safety
•
Assembly
•
Operation
•
Maintenance
•
Parts
List
•
Espa_ol
A
WARNING:
Read and follow all Safety Rules and Operating
Instructions before first use of this product.
For answers to your questions about this product:
Call 7 am-7
pm, Mon.-Sat.,
or 10 am-7
pm, Sun.
1-800-235-5878
_Hoors listed are Centre, Th'qe)
Sears,
Roebuck
and Co., Hoffman
Estates,
tL 60179
U.S.A.
530087872
8/10/01
Advertisement
Table of Contents
Related Manuals for Craftsman 358.797310
Summary of Contents for Craftsman 358.797310
- Page 1 Instruction Manual (RRFTSMR 24cc/1.4 cu.in. 2-Cycle 200 MPHi400 CFM GASOLINE POWERED BLOWER/VAC Model No. 358.797310 • Safety • Assembly • Operation • Maintenance • Parts List • Espa_ol WARNING: Read and follow all Safety Rules and Operating Instructions before first use of this product. For answers to your questions about this product: Call 7 am-7 pm, Mon.-Sat.,...
- Page 2 Maintenance Spanish Service & Adjustments Parts and Ordering Back FULL TWO YEAR WARRANTY ON CRAFTSMAN ® GAS BLOWER For two (2) years from date of purchase, when this Gas Blower is maintained, lubricated, and tuned up according to the instructions...
- Page 3 • Mix and pour fuel in an outdoor area; ing debris away from people, ani- store fuel in a cooI, dry, wel_ventilated mals, glass, and solid objects such pIace; use an approved, marked con- as trees, automobiles, waits, etc. The tainer for al} fuel purposes.
- Page 4 • Store in a dry area out of reach of Service for the correct kit. The spark children. arrestor, btower tubes, and nozzles must be assembled to unit to be in full SPECIAL NOTICE: For users on U.S. compliance with reguIations. Forest Land and in some states, in- cluding California(Public Resources...
- Page 5 Push the small end of the elbow 2. insert a screwdriver into the latch area on the vacuum inlet cover. tube through the small opening the bag. Elbow Tube Small Latch Area Opening Outlet Vacuum Latch Blower inlet Cover Zipper 3.
- Page 6 SHOULDER STRAP ADJUSTMENT (for vacuum use only) 1. Hold the unit as shown. Pass the shouider strap over your head and onto your right shoulder. Extend you left arm toward the rear of the vacuum bag. Adjust shouider strap until the vac- uum bag/shoulder strap seam lies between...
- Page 7 2-cycle air-coo_ed engine oil. attachments. Do not operate without We recommend Craftsman brand oil guard(s) in ptace. Mix gasoline and oil at a ratio of 40:1 • Operate power equipment only at rea- (A 40:1 ratio is obtained by mixing 3.2...
- Page 8 STARTING THE ENGINE more than 5 pulls (below 30oF, 8 pulls). _ll WARNING: You MUST make sure NOTE: If the engine attempts to start the tubes are secure before using the before the 5th putt, go to the next step unit.
- Page 9 CUSTOMER RESPONSIBILITIES CARE & MAINTENANCE TASK WHEN TO PERFORM Before each use Check for Loose fasteners and parts Before each use Check for damaged or worn parts Clean unit and IabeIs After each use Clean air filter Every 5 hours of operation Replace spark plug Yearly Replace fuel filter...
- Page 10 REPLACE FUEL FILTER Once each year, ensure muffler boits To replace fuel filter, drain unit by run- are secure and tightened properIy to prevent damage. Remove muffler cov- ning it dry of fuel, then remove fuel er and tighten the two muffler boIts cap/retainer assembly from tank.
- Page 11 5 minutes after adding unit before storing or transporting. stabilizer. • Store unit and fuel in a welt venti- Craftsman 40:1,2-cycle engine oil (air lated area where fuel vapors cannot cooIed) is already bIended with fuel reach sparks or open flames from stabilizer.
- Page 12 TROUBLESHOOTING TABLE WARNING: Always stop unit and disconnect spark plug before perform- ing any of the recommended remedies betow other than remedies that re- quire operation of the unit. CAUSE TROUBLE REMEDY Engine wiII not 1. Ignition switch off 1. Move Ignition switch to ON. start.
- Page 13 1-800-473-7247. WARRANTY part on your engine (as listed under Emissions Control Warranty Parts List) RIOD: Any warranted part which is not is defective or a defect in the materials scheduled for replacement as required or workmanship of the engine causes maintenance, or which is scheduled the failure of such an emission...