Craftsman 113.242720 Owner's Manual page 9

EXT. LOCKWASHER HEX. HEAD SCREW
5/16 IN. I IN. LONG
INSTALLING RIP FENCE GUIDE BARS
1.
From among the loose parts find the following
hardware:
2 Hex. Head Screws, 5/16- 18 x 1-1/2 in. long
2 Hex. Head Screws, 5/16- 18 x 1 in. long
4 Hex. Nuts, 5/16- 18 (approx. dia. of hole 5/16 in.)
4 External Lockwashers, 5/16 in. (approx. dia. of hole
5/16 in.)
4 Flat Washers(Dia. of hole 21/64 in.)
2 Spacers, 3/4 in. dia. x 1/2 in. long
2 Self-threading nuts
2. Position guide bars on floor and install hardware as
shown.., do not screw nuts on all the way.
FLAT WASHER
HEX NUT
5/16 IN,
REAR GUIDE BAR
3. Place front guide bar against saw table and drop it in
place ... engaging the screws in the slots. Make sure the
spacers are between the rail and the table.
4. End of front guide bar must be 5-13/16 in. from side of
saw table. This is important so that rip fence Indicator
can be aligned.
5.
With the blade of your combination square set to 1/4
in., use it as a gauge and attach the rail so that the edge
of the rail is 1/4 in. ABOVE the edge of the table.
6. Remove the three screws from rear of table extension.
7. Insert ends of FENCE GUIDE BAR ROD through
round holes at outer end of bars.
NOTE: The ends of the ROD are not threaded ... the
SELF THREADING NUTS will cut threads on the rod
as they are'screwed on.
8. Attach the rear bar in a similar manner, but make sure
that the end of the bar is 10-11/16 in. from the side of
the saw table.
FENCE GUIDE BAR ROD
9