Installing Feed Handles - Craftsman REXON 137.229171 Operator's Manual

INSTALLING THE HEAD (FIG. D)
TheDrill Press head is very heavy and MUST be lifted
withthe help of 2 PEOPLE OR MORE, to safely
assemblethe Drill Press head on the column.
1. Carefully liftthe head (1) above the column (2) and
slide it onto the column. Make sure the head slides
down over the column as far as possible. Align the
head with the base.
2, Using the hex wrench, tighten the two head lock set
screws (3) on the right side of the head.
Fig. D
1
FENCE ASSEMBLY (RG. F)
This drillpress has a channeled table top.
1. Determine the desired locationfor the fenco (1). Slide
the T-blocks(2) into_ appropriatechannels as
shown.
2. Align the mountingholes of the fence over the T-block's
threaded holes.
3. Place a washer (3) on the threaded end of the knob (4).
Insert the knobthrough the mounting hole of the fence
into the T-block,and tighten.
4. Repeat for the other knob and T-block.
Fig. F
INSTALLING FEED HANDLES (FIG. E)
1. Locate three feed handles in the loose parts bag.
2. Screw the feed handles (1) into the threaded holss (2)
in the hub (3). Tighten.
Fig. E
2 3