Advertisement
•
If thetopor bottom ofthesawbladeanglesaway
fromthesquare as shown infigures 30and31,
adjustments areneeded.
FENCE
COMBINATION
MITERTABLE
SQUARE
VIEW OF BLADENOT SQUAREWITH MITER
TABLE,ADJUSTMENTS ARE REQUIRED Fig. 30
Using a 10 mm wrench or adjustable wrench,
loosen the lock nut securing positive stop adjust-
ment screw. Also loosen bevel lock knob.
Adjust positive stop adjustment screw to bring
saw blade into alignment with the square.
See Figure 32.
MITER
TABLE
BEVEL
POSITIVESTOP
LOCKKNOB
ADJUSTMENT
FOR0
LOCKNUT(S)
FENCE
POSITIVE
STOPADJUSTMENT
SCREWFOR45° ANGLES
Fig. 32
Retighten bevel lock knob. Next, retighten lock nut
securing the positive stop adjustment screw.
Recheck blade-to-table alignment.
Note: The above procedure can be used to check
blade squareness of the saw blade to the miter
table at both 0 ° and 45 ° angles.
BLADE
COMBINATION
MITERTABLE
SQUARE
VIEW OF BLADENOTSQUAREWITH MITER
TABLE,ADJUSTMENTS ARE REQUIRED Fig. 31
22
Advertisement
