Advertisement
Note: Many of the illustrations in this manual show
only portions of your compound miter saw. This is
intentional so that we can clearly show points being
made in the illustrations. Never operate your saw
without all guards securely in place and in good
operating condition.
SQUARING
THE MITER TABLE
TO THE FENCE
See Figures 21- 24.
•
Remove battery pack from saw.
,4_
WARNING:
Failure to remove battery pack from
your saw could result in accidental starting
causing possible serious personal injury.
Push down on the saw arm and pull out the lock
pin to release the saw arm.
Raise saw arm to its full raised position.
Lift the miter table clamp.
Rotate the miter table until the pointer is posi-
tioned at 0 ° .
Push the miter table clamp back down.
Lay a framing square flat on the miter table. Place
one leg of the square against the fence. Place the
other leg of the square beside the throat plate in
the miter table. The edge of the square and the
throat plate in the miter table should be parallel as
shown in figure 21,
FENCE
FRAMING
SQUARE
MITER
TABLECLAMP
•
If the edge of the framing square and the throat
plate in the miter table are not parallel as shown
in figures 22 and 23, adjustments are needed,
FENCE
FRAMING
SQUARE
THROATPLATE
MITERTABLE
VIEWOF MITERTABLENOT SQUAREWITH
FENCE,ADJUSTMENTS AREREQUIRED Fig. 22
FENCE
FRAMING
SQUARE
THROATPLATE
MITERTABLE
VIEWOF MITERTABLENOT SQUAREWITH
FENCE,ADJUSTMENTS ARE REQUIRED Fig. 23
MITERTABLE
THROATPLATE
VIEWOF MITERTABLESQUAREWITH
FENCEANDCORRECTLY ADJUSTED
Fig. 21
19
Advertisement
