Advertisement
FENCE
BLADE
MITERTABLE
FRAMINGSQUARE
VIEWOF BLADENOT SQUAREWITH
FENCE,ADJUSTMENTS ARE REQUIRED Fig. 27
Using the 6 mm hex key provided, loosen the
socket head screws that secure the mounting
bracket to the miter table. See Figure 28.
6 mm
HEX KEY
6 mm SOCKET.
HEADSCREW(S)
MITERTABLE
Fig. 28
Rotate the mounting bracket left or right until the
saw blade is parallel with the square.
Retighten the screws securely and recheck the
blade-to-fence
alignment.
SQUARING
THE BLADE TO THE
MITER TABLE
See Figures 29 - 32.
•
Remove battery pack from saw.
,_,
WARNING:
Failure to remove battery pack from
your saw could result in accidental starting
causing possible serious personal injury.
Pull the saw arm all the way down and engage
the lock pin to hold the saw arm in transport
position.
•
Lift up the miter table clamp.
•
Rotate the miter table until the pointer is posi-
tioned at 0 °.
Push the miter table clamp back down.
Loosen bevel lock knob and set saw arm at 0 °
bevel (blade set 90 ° to miter table). Tighten bevel
lock knob.
Place a combination square against the miter
table and the flat part of saw brade.
Note: Make sure that the square contacts the flat
part of the saw blade, not the blade teeth.
•
Rotate the blade by hand and check the blade-to-
table alignment at several points.
•
The edge of the square and the saw blade should
be parallel as shown in figure 29.
FENCE
BLADE
COMBINATION
MITERTABLE
SQUARE
VIEW OF BLADESQUARE
WITH MITERTABLE
Fig. 29
21
Advertisement
