Advertisement
LED FUNCTION
OF CHARGER
See Figures 5 & 6.
LED WILL BE LIGHTED TO INDICATE STATUS OF
CHARGER AND BATTERY PACK:
•
Red LED Lighted = Fast Charging Mode.
•
Green LED Lighted = Fully Charged And Slow
Charging To Maintain Battery Pack.
•
Red LED Flashing = Hot Or Deeply Discharged
Battery Pack. Also Defective Battery Pack After 1
Hour.
•
Yellow LED Lighted and Red LED Flashing =
Defective Battery Pack.
YELLOWLIGHT"ON" ANDRED
LIGHTFLASHINGINDICATES
DEFECTIVEBATTERYPACK
IMPORTANT
INFORMATION
FOR
RECHARGING
HOT BATTERIES
Under extreme continuous use, the batteries in your
battery pack will become hot. You should let a hot
battery pack cool down for approximately
1 hour
before attempting to recharge. When the battery pack
becomes discharged and is hot, this will cause the red
light on your battery charger to flash. When battery
pack cools down, red light will glow continuously
indicating fast charging mode, 1 hour charge time.
Once the battery pack cools down, it will recharge
battery pack in fast charging mode as normal.
Note: This situation only occurs when extreme
continuous use of your saw causes the batteries to
become hot. It does not occur under normal
circumstances.
Refer to "CHARGING
BATTERY
PACK" for normal recharging of batteries. If the
charger does not charge your battery pack under
normal circumstances, return both the battery pack
and charger to your nearest Sears repair center for
electrical check.
MOUNTING
CHARGER
See Figure 7.
Your charger has a "key hole" hanging feature for
convenient, space saving storage. Screws should be
installed so that center distances are 4-1/8 inches
apart.
REDLIGHT"ON"
CHARGER
INDICATESFAST
CHARGINGMODE
GREENLIGHT"ON" INDICATES
FULLYCHARGEDANDSLOW CHARGING
TO MAINTAINBATTERYPACK
Fig. 5
4-1/8in.
BACKSIDE OF CHARGER
Fig, 7
CHARGER
BATTERYPACKSHOWN
IN CHARGER
Fig. 6
12
Advertisement
