Advertisement
TO INSTALL
BLADE
See Figures
17, 18, 19and20.
_L
DANGER:
A 8-1/4 in. blade is the maximum
blade capacity of your saw. Never use a blade
that is too thick to allow outer blade washer to
engage with the flats on the spindle. Larger
blades will come in contact with the blade
guards, while thicker blades will prevent the
blade screw from securing the blade on the
spindle. Either of these situations will result in a
serious accident and can cause serious personal
injury.
•
Remove battery pack from saw.
,_
WARNING:
Failure to remove battery pack from
your saw could result in accidental starting
causing possibte serious personal injury.
Push down on the saw arm and pull out the lock
pin to release saw arm. Raise saw arm to its full
raised position. Be cautious, saw arm is spring
loaded to raise.
Loosen the phillips screw on the blade bolt
cover until blade bolt cover can be raised.
See Figure 17.
Gently raise the lower blade guard bracket,
releasing lower blade guard from notch so that
lower blade guard and blade bolt cover can be
rotated up and back to expose the blade bolt.
See Figure 18.
BLADEBOLTCOVER
PHILLIPSSCREW
\
Fig. 17
LOWERBLADE
GUARD BRACKET
BLADEBOLTCOVER
To I
LOOSEN'
'_GHTEN
BLADEBOLT
LOWER
BLADEGUARD
ILLIPS
SCREW
BLADEBOLT
Fig. 18
LOWER
BLADEGUARD
PHILLIPS
SCREW
FLAT(S)
ON SPINDLE
\
INNERBLADE
DOUBLE"D"FLATS
BLADE
OUTERBLADEWASHER
WITH DOUBLE"D"FLATS
Fig. 19
17
Advertisement
