Craftsman 315.115810 Operator's Manual page 14

BIT STORAGE
See Figure9.
When not in use, bits provided with the drill can be placed
in the storage arealocatedon the base of the drill.
SCREWDRIVER BIT
Btf STORAGE AREA Fig, 9
INSTALLING BITS
See Figures 10 - 11.
Lock the switch trigger by placing the direction of
rotation selector in the center position_
u Open or close the chuck jaws to a point where the
opening is slightly larger than the bit size you intend to
use° Also, raise the front of the drill sfightty to keep the
bit from falling out of the chuck jaws.
u Insert the drill bit,
a Tighten the chuck Jaws on the drill bit,
• _k WARNING: Do not insert driP) b it }nto chuck Jaws
and _ighten as shown in ?ig_Jre11, This could cause
drill bit to be thrown from drift resulting in possible
sertotzs personal injury or damage to the chuck_
m Rotate the chuck clockwise to tighten the chuck )aws
securety on the bit,
NOTE: Rotate the chuck body in the direction of the
arrow marked LOCK to tighten the cL_ck {aws, Do r_ot
use a wrench to tighten or loosen the chuck iawso
CHUCK
COLLAR
LOCI(
(TIGHTEN) CHUCK
BODY
RIGHT
Fig° 10
Fig. 1"/
REMOVING BITS
See Figure 40.
= Lock the switch trigger by piecing the direction of
to,Lion selector inthe center posiLion,
eBRotate the cf_ucks(eev_ c{ockwise to open the cf_uck
iaws,
NOTE: Rotate the chuck body in the direction of the
arrow marked UNLOCK to loosen the chuck jaws, Do
not use a wrench to tighten or loosen the chuck jaws.
=1 Remove the drill bit.
14