Craftsman 113.243401 Owner's Manual page 9

assembly
MOUNTING BAND SAW/SANDER ON FLOOR STAND
NOTE: For illustrative purposes, the Band Saw is shown
mounted on the Craftsman Catalog No. 9-22:236 Steel Leg
Set. This Leg Set is included with Model No. 113.243411.
1. Remove the Band Saw cover by applying gentle side
pressure on the spring tabs and release the top portion
of the cover by pulling it away from the frame. Repeat
procedure for bottom portion of cover.
NOTE: Check the bolts which hold the feet to the Band
Saw as shown. Make sure they are tight.
LEFT
FOOT
CHECK BOLTS
FOR
RIGHT
FOOT
2. Place the Band Saw on the Steel Legs, position as shown,
and align the mounting holes in the feet of the Band Saw
with those in the END STIFFENERS (marked with an X
in the illustration).
O O
;o0
©O
O
o
O
O
0Oo
o O
MOTOR SUPPORT AT THIS END
MOTOR PULLEY BELT GUARD AND MOTOR
INSTALLATION
MOUNTING BELT GUARD
1. Place the motor on your workbench with the shaft
facing you.
If you are using a double shaft motor, the 5/8" alia.
shaft must be facing you.
2. A_ach guard support to the bracket with the two
screws, furnished with the guard.
NOTE: The holes in the bracket are not threaded, but the
screws are "thread cutting screws" and will cut a thread as
they are tightened.
BELT GUARD
SUPPORT BRACKET
THREAD CUTTING
SCREWS
BELT GUARD
SUPPORT