Accessories And Attachments; Available Accessories; Constructing A Featherboard - Craftsman 351.221140 Owner's Manual

AVAILABLE ACCESSORIES
May be available at your Sears Hardware Department or
see the Sears Power and Hand tool Catalog or visit
WWW.SEARS.COM for the following accessories.
iTEM
* Auxiliary Fence, Rip Fence
* Miter Gauge Extension & Stop
* Stock Clamp, Miter Gauge
* Dust Chute with Dust Port
* Micro-Adjustment Assembly
* Table Insert - Standard
* Table Insert - Dado
* Table Insert - Molding Cutterhead
* Table Insert - Zero Clearance
* Fence Guide System
STOCK NUMBER
29878
29879
29880
22102
29881
29882
29885
29887
29889
32371
Sears may recommend other accessories not listed in
this manual.
See your nearest Sears Hardware Department or Sears
Power and Hand Tool Catalog for other accessories.
Do not use any accessory unless you have completely
read the Owner's Manual for that accessory.
Use only accessories recommended for this table saw.
Using other accessories may cause serious injury and
cause damage to the table saw.
Fig. 2A
CONSTRUCTING A FEATHERBOARD
24"
[
I
kerf should be
about 1/4" apart I
I
I
[
5"
Figure 2A illustrates dimensions for making a typical
featherboard. The material, which the featherboard is
constructed of, should be straight piece of wood that is
free of knots and cracks. Featherboards are used to
keep the work in contact with the fence and table and
help prevent kickbacks. Clamp the featherboard to the
fence and table so that the leading edge of the feather-
board will support the workpiece until the cut is com-
pleted.
Use featherboards for all non-through cutting opera-
tions where the guard and splitter assembly must be
removed. Always replace the guard and splitter
assembly when the non-through cutting operations
are finished. See figure 2B.
Fig. 2B