Advertisement
STEP 4: (SEE FIGURE 4)
=
Assemble a spacer, a washer, a wheel (air valve
facing out) and another washer onto the end of the
axle that has both the large and small holes.
Install a 1/8" x 1-1/2'" cotter pin into the small hole in
the end of the axle.
Open the bail on the drive pin and install it through
the wheel and the large hole in the axle. Close the
bail to lock the pin in place.
118 x 1-1/2
COTTER PIN
WHEEL
WASHER
WASHER
DRIVE PIN
/
SPACER
FIGURE 4
STEP 6: (SEE FIGURE 6)
=
Turn the spreader upright on its wheels.
=
Hook the double bent end of the flow control rod
through the hole in the slide gate bracket located near
the bottom of the hopper,
FIGURE 6
STEP 5: (SEE FIGURE 5)
=
insert the end of the flow control rod with only one
bend into the hole in the lever on the flow control tube
assembly,
STEP 7: (SEE FIGURE 7)
=
Assemble the flow control mounting tube to the hitch
tube using two 5/16" x 1-3/4" hex bolts and 5/16"
nylock hex nuts, DO NOTTIGHTEN
YET.
FIGURE 5
FLOW
CONTROL
ROD
5116 x 1-3/4
HEX BOLT
5116 NYLOCK NUT
FIGURE 7
Advertisement
