Advertisement
Available languages
Available languages
CHARGINGTHE
BATTERY PACK conL (Fig. 4 and 4a)
B.The battery pack wift becomeslightiy warm to the touch while charging This is normal
anddoes not indicatea problem,
9. Do not place the battery chargingstand t transformer tn an area of extremeheat or cold,
it will work best at normal room temperalure.
10. When baitery pack becomes fuIly charged, unplug battery charging stand I lransformer
from powersupply and remove lhe battery pack.
L_ CAUTION:
If at any time during the charging
process the green LED
light ls iIlumtneted,
remove
the battery pack tram the charging
stand. Replace
the battery
pack, and if the green LED light still comes on, take the charging
stand t transformer
In to be repaired
/ replaced.
L_ CAUTION:
If at any point during
the charging
process
neither of the LEDs
are lit, remove
the batter=/pack
from the charging
stand to avoid damaging
the
producL
Do not insert another
battery,, Return the charging
stand / translormer
and battery
pack to your
nearest
service
center for service
or replacement.
CHARGING
A HOT
BATTERY
PACK
When using your tool continuously, the batteries
in your batlery
pack will become
hot
You should let a hot battery
pack coot down for approximately
30 minutes before
attempting
to recharge-
NOTE: A hot battery pack only occurs when prolonged continuous use of your drill/driver
causes the batterfes to became hot. It does net occur with typical use.Within the
warranty period, if the battery pack becomes
hot with typical use, return the charging
stand/kansformer,
and battery pack to your nearest Sears store or other Craftsman outlet
for free replacemenL
INSTALLING
THE BATTERY
PACK
IN DRILL/DRIVER
(Fig.
5)
t. Place the Forward
/ Reverse
Selector
Swttch
wlth Power Lock-Off
inlo the center posilion
to
lock the power off,
2. Place lhe battery pack in the drill, aligning
the
raised rib on battery pack with groove inside
the drill,
3 Make sure the latches on each side of the
battery pack "snap" into place, and the batlery
pack is secured
tn the drill I driver before
beginning operation.
16
Advertisement
