Additional Rules For Safe Operation; Glossary Of Terms For Woodworking - Craftsman 320.2190 Operator's Manual

ADDITIONAL RULES FOR SAFE OPERATION
,_ WARNING: BE
SURE to read and understand ell instructions. Failure to /
follow all Instructions listed below may result in electric shock, fire and/or serious
J
personal Injury_
t Know your power tool. Read operator's manual carefully. Learn the applications
and ffmttat_ons,as well as the specific potential t_azards related to this laal Following
tilis rule wilt reduce the risk at electric shock, fire or serious Injury
2 ALWAYS wear safety glasses or eye shields when using this saw. Eve_day
eyeglasses have only impacFresistant lenses; they are NOT safety gtasses.
3 PROTECT your lungs., Wear a face mask or dust mask it the operation is dusty
4, PROTECT your hearing. Wear appropriate personal hearing protection during usa
Under some conditions noise from this product may contribute to heating toss
5 ALL VISITORS AND BYSTANDERS MUST wear the same safely equipment that 1he
operator o! lbe saw wears.
6 INSPECT the too! cords periodically and tl damaged have them repaired at your
nearest Sears Service Center, BE AWARE of the cord location,,
7, ALWAYS check the tool for damaged parts,, Before further use of the tool a guard or
other part tbal is damaged should be carefully checked to dete`rmlne if it wtlt operate
properly and perform its inlended function. Check for misalignment or binding of
moving parts, breakage of parts, and any artier condil{on that may aifect the tool's
operalion. A guard or ether part that is damaged should be properly repaired or
replaced at a Sears Service Center.
8 INSPECT and .remove all nails lrom lumber before sawing_
9. SAVE THESE INSTRUCTIONS, Refer to them frequently end use them to instruct
others who may use lhts tool,. If someone borrows this tool, make sure they have
these Instructions also.,
Saw Blade Path
The area over, under, behind or in lmnI el the blade, as it applies to the workpiece That
area which will be or has been cut by the blade,,
Set
The distance that the saw blade tooth is bent (or set) outward from the face of the blade
Strokes per Minute or Stroke Speed
The blade speed o| a sabre saw, which can ba varied, us_a!_y from 800 to 3000 strokes
per mlnule
Cross cut
A culling or shaping operation made agatns! lhe grain el the work piece
Bevel Cut
A cutting operation made wilh Ihe blade al any angle other than 90 ° lo lhe base
Ripping or Rip Cut
A cutting operation along the length el Ihe werkpiece
9-8-06
17235