Table of Contents
Advertisement
Remove two nuts from
one end of the top panel
frame. Remove end
piece. Slide decorative panel into
panel frame. Replace end piece
using nuts.
Refrigerkor
cabinet
112 I
Attach the brace to the
top tight front comer of
the refrigerator cabinet
with one screw. Insert top grille flange
into cabinet trim channel and align
grille with top and side trim. Attach top
grille mounting panel assembly to
brace with one screw. Fasten grille in
place with six screws.
Check that the power switch is in the
(14
Check the water
"ON" position. Attach top grille decora-
tive panel assembly to the keyhole
.
connections
at the
bottom of the refrigerator
bracket on the frame and pull down to
secure. If the top grille decorative
panel does not fit evenly within frame,
the keyhole bracket can be moved
side to side by adjusting the bracket
screws or the decorative panel bracket
can be moved up or down by adjusting
the decorator panel bracket nuts.
again for leaking.
Any leaking can
cause refrigerator
and floor damage.
Personal
Injury
Hazard
Reinstall
set screws after
door swing
Is set.
Failure
to so could result in
personal
injury.
ml
m
Check that doors can
open freely. If not, the
door stops or hinges
can be adjusted.
To adjust
horizontally:
Loosen set
screw in top and bottom hinges with
Allen wrench.
Determine the door
swing desired.
Hold door in that
position and tighten the set screws.
The doors have stops at 90°,
115O
and 137O positions.
If the door
stops cannot be adjusted to clear
countertops,
the countertops
may
need to be mitered. (Consult your
builder to adjust countertops.)
To adjust vertically:
Loosen, do
not remove, top and bottom hinge
screws. Lift door and bottom hinge
to desired position. Tighten bottom
hinge screws and then top hinge
screws.
B-l
m
Open both doors. Use
two screws to attach
bottom grille to cabinet.
Put shelves and bins
into the refrigerator and
freezer compartments.
Remove protective
film from door
frame.
1171
Set refrigerator
and
n
freezer compartment
.controls
to the midpoint
between "COLD"
and "COLDEST".
Check that the compressor
is op-
erating properly.
Check that all five
interior lights are working.
To get the most efficient
use from your new
built-in refrigerator,
read
your KitchenAid"
Use
and Care Guide. Keep
Installation
Instructions
and Guide close to
built-in refrigerator
for
easy reference.
Page 11
Advertisement
Table of Contents
