Table of Contents
Advertisement
Dimensions for built-in area
Personal
Injury/Property
Damage Hazard
) Unit is top-heavy
and may tip
forward when the doors are
opened.
D A solid soffii or 2" wood block is
required
above the refrigerator
to prevent tipping
during
use.
m If solid soffit is more than I inch
above refrigerator,
a wood block
must be installed
on the wall not
more than l/4 inch above the
refrigerator
cover.
Failure to follow these instructions
could result in personal injury or
property damage.
Width and depth of the built-in area
are determined
by the type of
installation.
The built-in refrigerator
can be installed with the doors flush
with the wall, with the doors
.protruding from the wall, or with side
panels enclosing refrigerator.
Select
one method of installation
and use
the dimensions
given for that
method as shown.
ouhded electrical
outlet location
+/- l/8" tolerance
Wall
plumbing
location
I
Floor
plumbing
location
Height of built-in area can range from
a minimum of 82-l/2"
to 84-3/4".
Op$onal top grilles may be required
for enclosures
less than 83-5/8".
Height dimensions
with optional top
grilles are given on page 4.
\
\
Eiectrlcal
outlet
should
be centered
wlthin
shaded
area.
/
E
Hole for plumbing
can be cut anywhere
r-
within
shaded
areas.
v
Dimensions
for tipping product
Front
tipping
radius
Side
tipping
radius
Page 3
Advertisement
Table of Contents
