Related Manuals for KitchenAid KSSS48MWX00
Summary of Contents for KitchenAid KSSS48MWX00
- Page 1 IMPORTANT: InstaltaQon Installer: Leave the HomeolsJner. \nst~ctions with Keep Installation Homeowner: instructions for future reference. Save installation Instructions for inspector’s use. local electrical...
-
Page 2: Parts Supplied For Installation
White, Black and Almond, and must permit the doors to open to a stainless steel door panel kit are at least 90”. available from your KitchenAid Because of the weight and size of dealer. Each kit includes door Floor Damage the built-in refrigerator, two or more panels and top grille panels. - Page 3 Dimensions for built-in area Personal Injury/Property Damage Hazard ) Unit is top-heavy and may tip forward when the doors are opened. Eiectrlcal outlet D A solid soffii or 2” wood block is should be centered wlthin shaded area. required above the refrigerator to prevent tipping during use.
-
Page 4: Product Dimensions
‘Top grille ..lmb.l me The 8-l/2” top grille is provided. maximum Smaller top grilles must be ordered exlension ,pye,pr” I4 -I,“‘. from your KitchenAid dealer. Check .-.-.;,a ,,-,,-a below rollers) the char-l below for the part numbers is used IO... - Page 5 Custom door panels, handle inserts and top grille panels Door and lop grille panels: Dimensions shown are with routed edges. Routing is required if panels are more than l/4” thick. Panel routing for door Relrigerator door panel and top grille panels. Freezer door panels +-l/4”...
- Page 6 Side panel requirements +I- i/8- tolerance 23-118” i protrudi door > installal < 110” spacer 23.716” deplh flush door installallon side lrlm Side trim Refrigerator One method is to altach side when 25” depth is available. If panel to outside of side trim. less than 25”...
-
Page 7: Electrical Requirements
Water supply Electrical Ground electric drillor use a hand drill. Drill a 3/l 6:’ hole in vertical requirements requirements cold water line. Attach a saddle valve to the water line with a Use only l/4” copper tubing clamp in an easily accessible water line. -
Page 8: Product Support
Product support Anti-lip / wood A solid soffit or a wood block block(s) is required to prevent refrigerator from tipping forward Block(s) must after it is installed. extend to fully cover width of cover. Determine what height the refrigerator will be when it is installed to fit opening. - Page 9 /4./ Move refrigerator to Now start... kitchen. Place cardboard or plywood under Remove top grille assembly Personal Injury Hazard refrigerator. Remove appliance package, literature package Because of the welght dolly. Open doors and remove all and pans bag taped to the slze of the built-in boxes, parts packages and packing refrigerator door and save.
- Page 10 supply cord Move refrigerator close to leveling rods cl&&wise using a 5/l 6” final position. Remove socket and ratchet until the cabinet cardboard or plywood from 15.1 weight is supported by the rear legs. under refngerator. Plug electrical Use l-3/8” open end wrench to lower cord into the grounded outlet.
- Page 11 Check that doors can built-in refrigerator, read into cabinet trim channel and align open freely. If not, the your KitchenAid” grille with top and side trim. Attach top door stops or hinges grille mounting panel assembly to and Care Guide. Keep can be adjusted.
- Page 12 The KitchenAid Consumer In the event that your KitchenAid Assistance Center will answer any appliance should need service, call Check that the circuit breaker is not questions about operating or the dealer from whom you tripped or house fuse blown.