Table of Contents
Advertisement
14. Press guard
onto
support
so that bottom
of
guard is approximately
3/4 in. away from
belt
with blade all the way down.
NOTE:
To remove guard,
lift up on LONG
TABS
of
clips..,
pull
guard
outward.
The
ciips
should
remain
on the BELTGUARD
SUPPORT,
f
/S/_
--
l
:341N.
ASSEMBLING
HOLD-DOWN
Locate
the clamp
assembly,
support
rod, two
wing
screws
and two washers
in loose parts bag.
Screw the support
rod (1) tightly
into the hole
in the
miter gauge
head.
Position
the clamp
assembly
(2) on the handle
and
rod ...
install washers
(3) and wing screws
(4).
NOTE:
The small knob (5) on the clamp screw
must
not turn. Check nut underneath
it...
itmust
be tight
against the knob. Use a 1/2 inch wrench to tighten
it.
2
MITER
GAUGE
NOTE:
The
slots for the Stop
Pin and the
angle
graduations
are manufactured
to close tolerances
which
provide
accuracy
for
most
woodworking
projects.
In
cases
where
greater
accuracy
is
required,
it is recommended
that a trial cut be made
and checked
before
cutting
the actual workpiece.
Before using the miter gauge, checkthatthe
head
of
the miter gauge
is square to its bar when the
Stop
Pin is indexed at 0 ° and the Lock Knob tightened,
if
the head is not square
with the bar, an adjustment
will be required.
To adjust the squareness of the Miter Gauge:
1. Loosen the two screws that hold the Indicator
Block 1/2 turn.
2. Loosen the Lock Knob.
3. Holding
the Miter Gauge Bar and Head firmly
against a square, tighten the Lock Knob. Recheck
the squareness.
4. if the Head is square to the Bar, tighten
the
two
screws for the Indicator
Block while pushing
the
Stop Pin firmly
into the 0° notch.
5. Align pointer with "0" mark on the head.
Looseness in the Miter Gauge Head can be removed
by adjusting
the set screw located on the underside
of the Head. Rotate the Head to a 60 ° position
and
turn
Miter Gauge
upside
down
to reach the
set
screw. Use a 1/8" Hex L wrench
to adjust.
There
should
be no up and down movement
in the
Head
HOLD
DOWN
CLAMP
BAR
STOP
PiN
" SQUARE
INDICATOR
BLOCK
SETSCREW
FOR
.
sw,vEL
LOOSEN
THESE
2 SCREWS
TO
ADJUST
INDICATOR
BLOCK
when
the Lock knob is loosened,
yet it must
swivel
freely.
22
Advertisement
Table of Contents
