Advertisement
POSITIONING
TABLE
AND WORKPiECE
Lock the table to the column
in a position
so that the
tip of the drill is just a little above the top of the work-
piece.
Always
place a piece of BACK-UP
MATERIAL
(wood,
plywood
. . .) on the table underneath
the workpiece.
This will prevent
"splintering"
or making
a heavy
burr
on the underside
on the workpiece
as the drill breaks
through.
To keep the backup
material
from spinning
out of control,
it must contact the left side of the column,
as illustrated,
WARNING:
TO
PREVENT
WORKPIECE
OR THE
BACKUP
MATERIAL
FROM
BEING
TORN
FROM
YOUR
HAND
WHILE
DRILLING,
POSITION
THEM
AGAINST
THE LEFT SIDE OF THE COLUMN.
IF THE
WORKPIECE
OR THE
BACKUP
MATERIAL
ARE
NOT LONG
ENOUGH
TO REACH
THE COLUMN,
CLAMP
THEM
TO THE
TABLE.
FAILURE
TO DO
THIS COULD
RESULT
IN PERSONAL
INJURY.
WORKPIECE
BAC K-U P..-"-_
MATERIAL
For small pieces that cannot
be clamped
to the table,
use a drill press vise (Optional
accessory),
WARNING:
THE
VICE
MUST
BE CLAMPED
OR
BOLTED
TO THE TABLE
TO AVOID INJURY
FROM
SPINNING
WORK AND VISE OR TOOL BREAKAGE.
WORKPIECE.
DRILL PRESS X
VISE
BOLT OR CLAMP
VICE SECURELY
BEVEL
LOCK
TILTING
TABLE
To use the table in a bevel (tilted) position,
loosen
the
set screw under table bevel lock with Hex 'L" wrench.
Loosen
beret
lock with an adjustable
wrench.
Tilt table to desired
angle by reading bevel scale. Re-
tighten bevel lock and set screw.
BEVEL SCALE
SET SCREW
J_
I::
p-
23
Advertisement
