Example Systems; Microsoft Ras - Nokia 9110 Setting Up Dial-In Service Manual

Hide thumbs Also See for 9110:

Table of Contents

Mobile Phones

3.1

4. EXAMPLE SYSTEMS

The dial-in system to the ISP or Intranet should be chosen carefully. Several manufacturers (such as Ascend,

Cisco, Hewlett Packard, Shiva, Digital, Sun and Morning Star) provide hardware and software dial-in solutions

which can be used with the communicator. Local computer dealers and manufacturers' web sites may provide

additional information regarding dial-in solutions.

The following examples of dial-in system configurations can be used as guidelines when creating a new dial-in

system or configuring an existing one.

This chapter will explain how to configure an existing Microsoft Windows NT 4.0 RAS service to work with the

Nokia 9110 Communicator.

Required configurations:

The TCP/IP settings must be configured properly on the RAS PC. These settings can vary so much that no

example can be given.

RAS must be set to " Allow any authentication including clear text" , in the encryption settings.

Note: If the " Allow any authentication including clear text" is not acceptable then the RAS can be configured to use

CHAP. This requires NT version 4.0 with Service Pack 2 or higher. The Service Pack information file (from

http://www.microsoft.com) gives information how to set this up.

The configuration for part 2, can be found in the Control Panel' s Network settings. Choose Remote Access Service

(and its properties) to get to the Remote Access Setup window (Figure 4.1).

Figure 4.1 Remote Access Setup Window

Note: In this example the communicator is set up to be used as the dial-in modem via the cable.

SETTING UP DIAL-IN SYSTEM

21.04.99

14 (16)

Table of Contents