Shiva Terminal Server Settings - Nokia 9110 Setting Up Dial-In Service Manual

Hide thumbs Also See for 9110:

Table of Contents

Mobile Phones

3.1

From the Remote Access Setup window, by choosing Network, one can find the Encryption settings in the

Network Configuration window. The communicator-supported settings for the encryption are illustrated in the

Network Configuration window (Figure 4.2). The Encryption settings are configured so that RAS does not require

encrypted password authentication. The dial-in client should support password encryption if encrypted passwords

are required.

Figure 4.2 Network Configuration Window

Usually these settings are adequate to get RAS working with the communicator. In some rare cases it is necessary

to remove all the settings which RAS makes to the dial-in modem when an incoming call is received. These

settings can be found in the modem.ini file. These settings are so case-dependent that no examples can be given.

4.2. Shiva Terminal Server Settings

The Shiva server uses SPAP as an authentication protocol by default, but the communicator does not support this

protocol. With Shiva, a TACACS server should be used (Nokia recommends the extended TACACS).

The following configuration is based on the Shiva Net Manager settings, with software version 4.0.1. When using

conventional modems, the PPP Restart Timer must be set to 10. Automatic disconnect time should be set to 15

minutes, especially if using international data calls. That is the only major configuration needed to make the Shiva

work. If using ISDN modems, then several other configuration changes are needed to make the system work. In

the [Serial *] category:

ISDNIncomingCallDefault = config

Rate adoption: V110

Rate: 9600

SETTING UP DIAL-IN SYSTEM

21.04.99

15 (16)

Table of Contents