Table of Contents
Advertisement
OPERATING
HEATER
AND LIGHTING
INSTRUCTIONS
Continued
INSPECTING
BURNER
!
TO TURN
OFF GAS TO APPLIANCE
SHUI-rlNG
OFF HEATER
1. Turn thermostat control knob clockwise ( _r ) to the "OFF"
position,
SHUTTING
OFF BURNER
ONLY (Pilot stays lit)
1. Turn thermostat control knob clockwise ( _
) to the "Pilot" position,
MANUAL LIGHTING
PROCEDURE
l. Follow steps I through6
under Lighting Instructions.
2. Whh control knob pressed in, strike match. Hold match to pilot until pilot
lights.
3. Keep control
knob pressed in for 30 seconds after lighting pilot. After 30
seconds, release control
knob.
Check pilot flame pattom and burner flame pattern often.
PILOT
FLAME
PATTERN
Figure 10 shows a correct pilot flame pattern. Figure l I shows an incorrect pilot
flame pattern. The incorrecX pilot flame is not touching the thermccouple, This
will cause the thermocouple
to cool. When the thermocouple
cools, the heater
vAll shut down.
Ther
Pilot Burner
Figure 10 - Correct Pilot Flame Pattern
Thermocouple
Pilot Burner
Figure 11 - Incorrect Pilot Flame Pattern
If pilot flame pattern is incorrect,
as shown in Figure 11
• turn heater off (see To TurnOffGas
to Appliance)
• see Troubleshoogng,
page 20
Advertisement
Table of Contents
