Planning - Craftsman 139.53902D Owner's Manual

Planning(Continued)
ONE-PIECE DOOR INSTALLATIONS
• Generally, a one-piece door does not require reinforcement. If
your door is lightweight, refer to the information relating to
sectional doors in Installation Step 12.
• Dependingon your door's construction, you may need
additional mounting hardware for the door bracket (Step 12).
Without a properly working safety reversal system, persons
(particularly small children) could be SERIOUSLYINJUREDor
KILLED by a closing garage door.
• The gap between the bottom of the garage door and the
floor MUST NOTexceed 1/4" (6 mm). Otherwise, the safety
reversal system may not work properly.
• The floor or the garage door MUST be repaired to eliminate
the gap.
ONE-PIECE DOORWITHOUTTRACK
Header Wall
FINISHED CEILING
Support bracket
& fastening
hardware is required.
See page 19.
Motor unit
Wall-mounted
Door Control
Sensor
Gap between floor
and bottom of door must not exceed 1/4" (6 mm).
Safety Reversing Sensor
_ader
all
Rail
Bracket
Door
CLOSED POSITION
Curved
Straight Door
Door
Arm
Arm
Rail Assembly
Emergency
Rope & Handle
ONE-PIECEDOORWITH TRACK
Access
_ __aGadP bo_tt w _en f_oorr Reversing Sensor
/ '
1
Safety must net exceed 1/4" (6 mm).
Reversing Sensor
Garage
Door
CLOSED POSITION
Bracket Trolley
Bracket
Straight
Door
Arm
Rail Assembly
Rope & Handle