Advertisement
Available languages
Available languages
ASSEMBLY
Your Craftsman generator requires some assembly
and is ready for use only after it has been properly
serviced with the recommended
oil and fuel.
If you have any probBems with the assembly
of
your generator,
please call the generator
helpline
at 1-800-222-3136.
IMPORTANT:
Any attempt to run the engine before it
has been serviced with the recommended
oil will result
in an engine failure.
Remove Generator
From Carton
1.
Set palleted carton on a rigid flat surface.
2.
Carefully cut bands around shipping carton.
3.
Lift carton off generator.
4.
Remove all packing material, carton fillers, etc.
5.
Remove generator from shipping pallet.
Carton
Contents
Check all contents. If any parts are missing or damaged,
call the generator helpline at 1-800-222-3136.
The main unit
Owner's manual
Engine oil
Wheel kit
Battery charger
Oil bottle funnel cap
120/240 Volt, 30 Amp locking plug
120 Volt, 20 Amp locking plug
120 Volt, 30 Amp locking plug
Battery charge cables
_nstaH Wheem Kit
The wheel kit is designed to greatly improve the
portability of your generator.
NOTE: Wheel kit is not intended for over-the-road use.
You will need a socket wrench with 1/2" or 13mm
sockets and a needle-nose
plier to install this kit.
Install the wheel kit as follows:
1.
Place generator on a hard flat surface.
2.
Stand at control panel end of generator and gently tilt
generator up, high enough to place wooden blocks
beneath cradle. This will allow you to add wheels.
3.
Slide axle through holes in brackets provided on
generator cradle.
4.
Slide a wheel spacer, wheel and flat washer on
one end of axle. Make sure air inflation valve is
outward. Place e-dng onto groove in axle.
5.
Place one end of needle nose pliers on bottom of
axle and other end of pliers on top of e-ring. Seat
e-ring by pressing pliers closed.
6.
Slide axle through until wheel is tight against bracket.
7.
Repeat steps 4 and 5 for opposite side. Remove
wooden blocks.
8.
Attach vibration mount to support leg with a 20mm
capscrew and lock nut.
9.
With wheels on, secure support leg assembly to
cradle with 20 mm long capscrews, flat washers,
and lock washers.
10. Check that all fasteners are tight and the tires are
inflated to the value marked on the tire or within
15 and 40 psi.
Whee_ Kit Assembly
View
Axle
Wheel Spacers
Wheel
Support Leg
Hex
V'brat'0n
_']_ _/'1---Fiat
Washer
Mount
-?
20mm _--L°ck
Washer
_--L_ap
_20mm
Cap Screw
Screw
Fiat
J
Washer E-Ring
Advertisement
