Advertisement
Available languages
Available languages
Prob{em
Engine Bsrunning,
but no AC
output
is available.
EngBne runs good at no-load but
"bogs down" when loads are
connected.
Engine wHI not start; or starts
CRuse
One of the circuit breakers is
open.
Poor connection or defective
cord set.
3.
Connected device is bad.
.
Fault in generator.
Short circuit in a connected
load.
Generator is overloaded.
3.
Engine speed is too slow.
4.
Shorted generator circuit.
Fuel valve in the "Off" position.
ignition Switch set to "Off".
Correction
Reset circuit breaker.
Check and repair.
3.
Connect another device that is
in good condition.
4.
Contact Sears service facility.
Disconnect shorted electrical
load.
See "Don't Overload
Generator".
3.
Contact Sears service facility.
4.
Contact Sears service facility.
Set fuel valve to the "On"
position.
Set switch to "On".
3.
Dirty air cleaner.
4.
Out of fuel.
5.
Stale fuel.
6.
Spark plug wire not connected
3.
Clean or replace air cleaner.
4.
Fill fuel tank.
5.
Drain fuel tank; fill with fresh
fuel.
6.
Connect wire to spark plug.
and runs rough.
to spark plug.
7.
Bad spark plug.
8.
Water in fuel.
9.
Overchoking.
7.
Replace spark plug.
8.
Drain fuel tank; fill with flesh
fuel.
9.
Open choke fully and crank
engine.
Engine shuts down during
operation.
10. Low oil level.
10. Fill crankcase to proper level.
11. Excessively rich fuel mixture.
11. Contact Sears service facility.
Out of fuel.
Fill fuel tank.
Load is too high.
Engine lacks power.
Dirty air filter.
Choke is opened too soon.
Engine "hunts"
or ratters.
Carburetor is running too rich or
too lean.
See "Don't Overload Generator"
Replace air filter.
Move choke to halfway position
until engine runs smoothly.
Contact Sears service facility.
21
Advertisement
