Setting The I/O Timeout Parameter - HP XP1024 System Configuration Manual

Setting the I/O timeout parameter

Set the I/O timeout value for each disk device to 30 seconds.
To change the I/O timeout parameter:
1. Verify the current I/O time-out value using the pvdisplay command:
Example
2.
If the I/O timeout value is not 30, change the value to 30 using the pvchange
-t command:
Example
38
Installation
# pvdisplay /dev/dsk/c0t6d0
- - - Physical volumes - - -
PV Name
VG Name
PV Status
Allocatable
VGDA
Cur LV
PE Size (Mbytes)
Total PE
Free PE
Allocated PE
Stale PE
IO Timeout (Seconds)
# pvchange -t 30 /dev/dsk/c0t6d0
Physical volume "/dev/dsk/c0t6d0" has been successfully changed.
Volume Group configuration for /dev/vg06 has been saved in
/etc/lvmconf/vg06.conf.
/dev/dsk/c0t6d0
/dev/vg06
available
yes
2
1
4
586
0
586 [OPEN-9]
0
default [I/O timeout value]