SGI IRIX Installation
1. Select the appropriate settings for each Fibre Channel port based on the device to
which the port is connected.
2. Determine the topology parameters supported by the device, and set your topology
accordingly.
3. The type of port is also important. If you plan to connect different types of servers
to the array through the same fabric switch, you must use the zoning function of
the fabric switch.
Table 1. Fabric Parameter Settings on the Remote Console PC
Fabric
Parameter
Connection Parameter
ON
FC-AL
ON
Point-to-Point
OFF
FC-AL
OFF
Point-to-Point
Port Address
In fabric environments, the port addresses are assigned automatically by fabric switch
port number and are not controlled by the port settings. In arbitrated loop
environments, the port addresses are set by entering an arbitrated-loop physical address
Provides
FL-port (public arbitrated loop)
F-port (fabric port)
AL-port (private arbitrated loop)
Not supported
17