HP Surestore Disk Array 12h - And FC60 Configuration Manual page 34

Example
Example
Example
Example
34
The default display for drive capacity is 512-byte blocks. To view the capacity of
the drives in kilobytes rather than in 512-byte blocks, enter
df –k
# df -k
File system
/dev/root
/dev/dsk/dks8d0l13s0
#
To mount and verify the new file systems:
1. Mount all registered file systems by entering
mount –a
2. To verify the operation of each new file system, go to the mount directory for the
file system to be verified. For example, enter
cd /HP5700_LU0
3. Copy any file to the mount directory. For example, enter
cp /unix.backup1 /HP5700_LU0/unix.back1
4. To verify the file copy operation, list the files in the current directory by entering
ls –1
# ls -l
total 7240
-rwxr-xr-x 1 root
5. Copy the file again to the mount directory, but in this case change the file name to
unix.back2. For example, enter
cp /unix.backup1 /HP5700_LU0/unix.back2
6. List the files again to verify the second file copy operation.
# ls -l
-rwxr-xr-x 1 root sys 3754720 Mar
-rwxr-xr-x 1 root sys 3754720 Mar
7. Remove the files you copied by entering
rm file_name
# rm /HP5700_LU0/unix.back1
# rm /HP5700_LU0/unix.back2
8. Repeat steps 2 to 7 for each new file system to be verified.
hp surestore disk array xp operating system configuration guide: SGI IRIX
Type Kbytes use
xfs 969857 414702
xfs 1048576 13
sys 3754720 Mar 4
4 15:08
4 15:08
avail %use Mounted on
555155 43 /
1048563 0 /HP5700-LU00
15:08 unix.back1
unix.back1
unix.back2