Port State Description; Table 5 Port State Description - HP StoreFabric SN6500B Administrator's Manual

2
Enabling and disabling Access Gateway mode
7.
8. Enter the ag
9. Enter the switchShow command to display the status and port state of all ports. Refer to the
10. Enter the switchDisable command to disable the switch.
11. Enter the ag command with the ---modedisable option to disable AG mode.
12. Enter the ag

Port state description

Table 5
TABLE 5
State
No _Card
No _Module
Mod_Val
Mod_Inv
No_Light
No_Sync
In_Sync
Laser_Flt
Port_Flt
Diag_Flt
14
Enter the ag modeshow command to verify that AG mode is enabled.
--
switch:admin> ag --modeshow
Access Gateway mode is enabled.
You can display the port mappings and status of the host connections to the fabric on Access
Gateway.
mapshow command to display all the mapped ports.
--
The ag mapshow command shows all enabled N_Ports, even if those N_Ports are not
--
connected.
Fabric OS Command Reference Manual for examples of output. For a description of the port
state, refer toTable 5 on page 14.
When you disable AG mode, the switch automatically reboots and comes back online using the
fabric switch configuration; the AG parameters, such as port mapping, and Failover and
Failback, are automatically removed. When the switch reboots, it starts in Fabric OS Native
mode. To rejoin the switch to the core fabric, refer to
on page 79.
switch:admin> switchdisable
switch:admin> ag --modedisable
modeshow command to verify that AG mode is disabled.
--
switch:admin> ag --modeshow
Access Gateway mode is NOT enabled
describes the possible port states.
Port state description
Description
No interface card present
No module (GBIC or other) present
Module validation in process
Invalid module
Module is not receiving light
Receiving light but out of sync
Receiving light and in sync
Module is signaling a laser fault
Port marked faulty
Port failed diagnostics
"Rejoining Fabric OS switches to a fabric"
Access Gateway Administrator's Guide
53-1002743-01